Datasheet

ManualsBrandsTE Connectivity ManualsConnectorsD-Sub Plug 9 Male IDC

1 of 3

TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks.

*Trademark. Other logos, product and/or Company names may be trademarks of their respective owners.

Instruction Sheet

TOOLING ASSISTANCE CENTER

1-800-722-1111



PRODUCT INFORMATION

1-800-522-6752

This controlled document is subject to change.

For latest revision and Regional Customer Service,

visit our website at www.te.com

LOC B

408-9833

Connector-Specific Kit 768349-1

for AMP-LATCH* HDF

Low-Profile Connectors

28 Mar 11 Rev D

PROPER USE GUIDELINES

Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use

and low volume applications. A wide selection of powered application equipment for extended-use, production operations is available.

Figure 1

1. INTRODUCTION

This instruction sheet covers the description, cable

requirements, and installation procedures for

Connector-Specific Kit 768349-1, which is used with

AMP-LATCH Hand Tool Kit 768340-1 (see Instruction

Sheet 408-9828) and Base Assembly Universal Arbor

Tool 768338-1 (see Instruction Sheet 408-9827). The

connector- specific kit will terminate AMP-LATCH HDF

Low-Profile Connectors having 1.27 mm [.050 in.]

centerline spacing to ribbon cable (see Figure 2).

The Base Assembly Universal Arbor Tool is used with

Manual Arbor Frame Assembly 91085-2 and

Pneumatic Auto-Cycle Unit 91112-3. Refer to

Instruction Sheets 408-7777 and 408-6732,

respectively, for tooling information.

Connector-Specific Kit 768349-1

Lower Insert

Locators

Upper Tool

Typical Applications

AMP-LATCH Hand

Tool Kit 768340-1

(Ref)

Manual Arbor Frame

Assembly 91085-2 (Ref)

Base Assembly

Universal Arbor

Tool 768338-1

Summary of content (3 pages)

PAGE 1
Instruction Sheet Connector-Specific Kit 768349-1 for AMP-LATCH* HDF Low-Profile Connectors 408-9833 28 Mar 11 Rev D PROPER USE GUIDELINES Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
PAGE 2
408-9833 NOTE i Dimensions in these instructions are in metric units [with U.S. customary units in brackets], unless otherwise indicated. AMP-LATCH Hand Tool Kit 768340-1 (Ref) (Includes  AMP-LATCH Hand Tool Subassembly 768942-1 and  Base Assembly Universal Hand Tool 768339-1.) Locators Reasons for reissue are provided in Section 6, REVISION SUMMARY. 2. DESCRIPTION (Figure 1) The connector-specific kit features an upper tool, two locators, and a lower insert.
PAGE 3
408-9833 For additional information concerning connectorspecific kits, or to purchase additional kits, contact your local TE Connectivity Representative or: Base Assembly Universal Arbor Tool 768338-1 (Ref) Locators CUSTOMER SERVICE (038-035) TYCO ELECTRONICS CORPORATION PO BOX 3608 HARRISBURG PA 17105-3608 Upper  Tool 6. REVISION SUMMARY Updated document to corporate requirements.