Reference manual – Firmware 1.2.
About this document 2 Release Notes – overview 2 Increased Tap Tempo popup & Allow Tempo Scrolling 8 Looper LED flashes 8 Basic user interface/menu structure changes 3 Loop Trigger Buttonmap highlight 8 MIDI Sync Looping and MIDI Sync 3 3 Increased Mix Parameter Range 9 MP-76 Support 4 Loop Controls on Switch-3 and Switch-6 5 Looper feeds NaturalPlay 5 Mix RoomSense into NaturalPlay 6 Input LEDs now reflect both Guitar and Vocal Level 6 Improved expression pedal response 6 Ta
VoiceLive 3 Firmware 1.2 Update Manual Addendum VoiceLive 3 Reference manual – firmware 1.
Release Notes – overview About this document This document applies to VoiceLive 3 firmware version 1.2.02 and HIGHER.
MIDI Sync Basic user interface/ menu structure changes MIDI Sync Looping and MIDI Sync First, there has been a small user interface change to clean up some of the menus, now that there’s a lot more things to control externally with VoiceLive 3. MIDI sync allows you to send tempo information from an external device (computer, keyboard, sampler etc.) to VoiceLive 3 and have it maintain the same tempo as the Master device.
MP-76 Support MP-76 Support In practice, it’s pretty cool. You can… ►►play audio and control the tempo from your DAW, We have added support for our MP-76 microphone to VoiceLive 3. Now you can control any of the vocal effects or create loops directly from the mic. ►►have your Guitar and Vocal Delay and Rhyth- mic effects line up with the audio track ►►record and play back loops in time with your DAW audio tracks.
Looper feeds NaturalPlay Loop Controls on Switch-3 and Switch-6 After many requests for simple loop access via Switch-3 and Switch-6, we have added some controls for Track A of the VoiceLive 3 looper. For more advanced interaction with the looper, we still recommend using the Loop layer, since the UI changes contextually based on actions you perform. Keep in mind that loop controls assigned to Switch 3/6 still adhere to the options for the currently active loop slot, like Sync, MET, Input etc.
Improved expression pedal response Mix RoomSense into NaturalPlay Input LEDs now reflect both Guitar and Vocal Level Improved expression pedal response This parameter, available in SETUP – SYSTEM, allows you to have audio from the RoomSense mics blended with other incoming NaturalPlay information (like guitar) to enhance accuracy. If you play your guitar without singing, the LEDs show your guitar level. If you sing and don’t play guitar, the LEDs show your vocal level.
Improved Chord Detection Accuracy Talk Trim allows OFF Improved Vocal Cancel Improved Chord Detection Accuracy Setting the Talk Trim parameter to OFF allows you to mute the microphone during TALK/TUNER mode. When used in combination with pressing/holding the Preset UP/DN buttons to enter TALK/TUNER (which mutes the guitar), you can effectively mute both guitar and vocal output from VoiceLive 3. We have tinkered with the Vocal Cancel feature to work with a wider range of mixes and song types.
Loop Trigger Buttonmap highlight Increased Tap Tempo popup Looper LED flashes Loop Trigger Buttonmap highlight When you’re in the Vocal or Guitar layer and have a Loop playing, the small red LED next to the Looper button will flash. This gives a visual indication that a loop is running. When you play a Loop Trigger, the on-screen button will now light correctly, just like the other effects do when they are active.
Increased Mix Parameter Range Increased Mix Parameter Range Some folks said our Mix controls didn’t go low enough for a good mix, especially with Aux type signals. We have increased the range of these parameters to give you more control. VoiceLive 3 Reference manual – firmware 1.
Increased Mix Parameter Range VoiceLive 3 Reference manual – firmware 1.
