Multi Sensor(MS01) 10.15.
Contents Device Overview .......................................................................................................... 3 Features ................................................................................................................... 3 What’s Included........................................................................................................ 3 Requirements ...........................................................................................................
Device Overview Set Button Screw or Tape for securing mount to surface Lens Magnetic Mount Device QR/ID Lithium Battery CR123A To open twist lens and back in opposing directions Features Automatically turn lights on when entering a room Automatically turn lights off after a period of inactivity Long detection range of 30 feetwith wide110 degrees field of view Use indoor or outdoor Able to be paired manually to Smart Lighting products for installations not requiring a smart bridge
Magnetic mount o Adhesive tape o Mounting screw Quick start guide Requirements Smart Lighting products Bridge for app-basedsetup, configuration, and access to other sensing capabilities Installation Power on the sensor 1. Open the case: with the lens side facing you, grasplens with one hand and the back cover with the otherand twistthe lens counter clockwise. It will turnand stop about 1/8”. Pull lens and back cover apart. 2.
Choosinga location for the sensor General placement considerations - TBD Indoor - TBD Outdoor - TBD Mounting sensor The sensor mount is magnetic which allows you to easily attach it and the sensor to a metal surface. Or it can simply be placed on any flat surface. Alternatively, you can permanently attach it by way of removing the backing on the adhesive tape and pressing it firmly on a flat surface. A screw is also provided if mounting using adhesive isn’t secure enough.
Configure sensor to control groups of devices Perform any programming/setup near where you intend to permanently mount the sensor. This will ensure that expected location is or is not within range. Testing Tap the set button on the sensor to activate the linked devices. Tap again to de-activate. Manual Configuration Linking to control a light 1. Starting at the sensor, press and hold the set button for 3 seconds (it will beep and the LED indicator will begin blinking green) 2. At the switch a.
6. At each of the switches, follow these steps one at a time a. Adjust to your preferred lighting preset position (On, Off, 50%, etc.) Tip: if you want to adjust the speed at which dimmable switches fade to the preset position, follow the steps to set the fade speed. When finished, be sure to complete the steps here within 4 minutes. b. Press and hold the set button until you hear a double beep 7. When finished, tap the set button on your sensor(its LED will stop double blinking green) 8.
Factory Reset The following process will reset your device back to its factory settings. Things such as on-levels, fade speeds, links to other devices will be removed. 1. Remove the battery 2. Press and hold set button all the way in and hold down. 3. While holding down the set button, install the battery 4. The Sensor will start to beep 5.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15B of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio and television reception.