24V Power Barrow Operator’s Manual WARNING: Read carefully and understand all INSTRUCTIONS before operating. Failure to follow the safety rulesand other basic safety precautions may result in serious personal injury. Save these instructions in a safe place and on hand so that they can be read when required. Keep these instructions to assist in future servicing.
SPECIFICATIONS Item No. LBB02 Rating DC 24V/0.25HP/180W Loading Capacity 330lbs/150kgs Battery Specification 12V,7Ah*2 Speed Forward: 0-5km/h(0-3MPH) Variable, Reverse: 0-3.5km/h(0-2.2MPH) Variable Max. Cubage Max 4 Cubic Feet POWER BARROW SAFETY USE WARNINGS 1. Keep work area clean and well lit. Cluttered or dark areas invite accidents. 2. Do not operate power tools in explosive atmospheres,such as in the presence of flammable liquids, gases or dust.
BATTERY POWER TOOL USE AND CARE WARNINGS 1. Ensure the switch is in the off position before inserting battery pack. Inserting the battery pack into power tools that have the switch on invites accidents. 2. Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack. 3. Use power tools only with specifically designated battery packs.
ASSEMBLY Step 1: Fix drive axle(B) on bucket bracket(D) with four bolts M8x45(A) and four nuts M8(C). (See Figure 1) Figure 1 Step 2: Fix flat key(A) and wheels(B) on the drive axle(C) with nuts M14(D), pin 2.8x30(E). (See Figure 2) Figure 2 Step 3: Fix supporting leg(A) on bucket bracket(D) with two bolts M8x40(B) and two nuts M8(C).
TROUBLESHOOTING Problem(s) Possible Cause Corrective Action The power barrow does not run. Battery is not charged. Charge the battery pack according to the instructions included with you model. Check all the connectors and to see if any partis loose or not. Replace the damaged one with specific controller. See the battery indicator to check the volume. Charge the battery pack according to the instructions included with you model. Replace the battery with a new one. The wire is loose.
PARTS BREAKDOWN Part No. 5 Q’ty Part No. 1 Bucket Base 1 14 Controller 1 2 Drive axle 1 15 Right handle 1 3 Wheel assembly 2 16 Handlebar grips 2 4 Flat key 5x5x25A 2 17 Flange Bolt M8x40 8 5 Bolt M14 2 18 Left handle 1 6 Pin 2.
The presence of this logo on the product means that the disposal of the device is governed by directive 2012/19/EU dated July 4, 2012 on waste electrical and electronic equipment(WEEE). Any hazardous substance contained in electrical or electronic equipment can have a potential impact on the environment and health during its recycling. Consequently, at the end of the useful life of the device, it must not be disposed of with unsorted municipal waste.
Thank you for choosing RedRock products, if you have any questions, please contact online customer service.