Manualshelf

Instructions / Assembly

ManualsBrandsTatahance ManualsLighting6.5 in. W 1-Light Matte Black Sconce with Seeded Glass Shade (Set of 2)
1
Assembly & Installation Instructions
MODEL: A19010、A20005、A20006、A20007
IMPORTANT SAFETY INSTRUCTIONS:
•
Warning: If any special control devices are used with this fixture, follow the instructions carefully to assure
full compliance with N.E.C. requirements. If there are any questions, contact a qualified electric contractor.
•
Warning: This product can expose you to chemicals including lead, which is known to the State of California,
to cause cancer or birth defects or other reproductive harm. For more information, please go to
www.P65Warnings.ca.gov
•
Caution: Electrician installation highly recommended. All glass is fragile, use care when handling glass
component(s) and or lamp(s). Read instructions carefully and turn electricity off at the main circuit breaker
panel before beginning installation.
Important Notice:
This is a generic instruction sheet used for various fixtures.
The finish, numbers of heads/arms, and style of fixture / glass / shade / diffuser may vary.
(Required Supply Circuit: 120V, 60Hz. Bulb Type: 1*E26*40W Max)
Compatible Bulb Type
(NOT Included)
The mostly suggested bulb type is a 8W LED dusk-to-dawn A19 bulb
COMPONENTS INCLUDED IN THE PACKAGE
Fixture with
hardwares
Parts included in parts bag.
Parts X 2 for 2 pack item
ASSEMBLY & INSTALLATION STEPS:
1. Open the box from top, take out all the components, parts bag and manual from the box carefully.
2. Check all the components against the parts list. Make sure get each parts on list. If any parts missing
and glass damage, please contact the seller to get a replacement.
Parts are NOT included for which is shown as 0 under QTY.
PARTS LIST (Parts QTY X 2 for 2 pack item)
Part Name
QTY
Code
Part Name
QTY
Code
Junction Box
0
A
Wire
2
I
Leading Wire
0
B
Socket
1
J
(1.5") Mounting Screw
2
C
Socket Ring
1
K
Cross Bar Mounting Bracket
1
D
Glass
1
L
Stud
2
E
Light Bulb
0
M
Back Plate
1
F
Washer
2
N
Cap Nut
2
G
Wire Nut
3
H
3. Refer to the illustration while doing assembly and follow the steps as below:
I
Thread two studs (E) onto the mounting bracket (D) at proper position.
II
Attach the mounting bracket (D) to the junction box (A) by two mounting screws (C).
Adjust the mounting bracket to a horizental level.
III
Connect wires according to the wiring diagram as below.
IV
Attach the backplate (F) to two studs (E) and fix with two washers (N) and cap nuts (G).
V
Slide the glass (L) onto socket (J) and fix with socket ring (K), screw on the bulb (M).
Illustration of assembly and wiring:
I. E
D
II. C, D
A
III. B,I
H
IV. G, N, F
E
V. M, L, K
J

Summary of content (1 pages)