Congratulations on your purchase of a Ta ramps product. It was developed in a modern laboratory and with the latest technology. This manual covers all features, operations and instructions to solve any doubt that may arise during the installation. Please take some time to read it carefully in order to ensure the proper installation and the use of all benefits this product can offer. For questions, please call +55 (18) 3266-4050 or visit www.taramps.com.br.
Technical features HD 3000 MODEL 1 OHM 2 OHMS Lime eR MAXIMUM OUTPUT POWER @& 12.8VDC 1 OHM" 3000W RMS MAXIMUM OUTPUT POWER @ 12 8VD0 2 FEY Iran MAXIMUM OUTPUT POWER @ 12.6VDC 4 HOME" 1140W RMS MAXIMUM OUTRE POWER G1 12.
Bodleian gr cae ie 1 INPUT (R and L): Inputs of signals to be amplified. Connect these signals to RCA outputs of CD/DVD Player, using good quality shielded cables to avoid noise influence. 2-LEVEL: lt sets the amplifier Input sensitivity, which allows an optimal adjustment to the output signals levels of nearly all models of CD/DVD Players found in the market. 3 CROSSOVER HIGH PASS: Variable adjustment from 10Hz to 80Hz, which determines the beginning of the amplifier operating frequency.
Output and Power Connectors 1 FAN: The HD 3000 has an internal ventilation fans, and cannot be blocked. This cooler is controlled by an intelligent system (Smart Cooler). It only operates at full speed from a certain level of audio or temperature. This function ensures extended life of the cooler and a low-noise performance of your amplifier. 2 SPEAKER: Output {negative and positive) to transducers’ connection (speakers). Follow the polarity described and the minimum impedance recommended.
GEL ee le eee CAUTION: All connections to power supply, input and output connectors must be RCA Cable Ta ramps “illustrative images jE Examples of connections in the power supply input Note: Required battery bank capacity: At least 1500th it is compulsory to install protection fuses or circulate breakers the closest possible [L080 2 EEC from batteries, and the final value should be around 180A 21mm? (4 AWG 21mm? (4 AWG) Remote Cable 1,5mm® (15 AWG} Recommended wire gauge and fuse Positive / negative power s
Pulp connections exam es Caution: Observe the minimum impedance when installing. impedance lower than the recommended can damage the amplifier and void the warranty. CONNECTION EXAMPLE 1 OHM 2 ohms 2 etas 4 fan 4 ohms CONNECTION EXAMPLE 2 OHMS # chums 6 vba *Quip cables with 4mm? (11 AWG) gauge, calculated considering a maximum length of 2m Note: In case of horns and tweeters you must install a passive fitter in the positive terminal of the same ones (Consult transducer's manufacturer manual).