TANTALUS SYSTEMS CORP. RT-2200 Instruction Manual Copyright 2002 Tantalus Systems Corp. All rights reserved. No part of this publication, or any software included with it may be reproduced, stored in a retrieval system, or transmitted in any form or by any means including photocopying, electronic, mechanical, recording or otherwise without the prior written permission of the copyright holder. This document contains proprietary information of Tantalus Systems Corp.
Notice The information contained in this document is subject to change without notice. Tantalus makes no warranty of any kind with regard to this material, including, but not limited to the implied warranties of merchantability and fitness for a particular purpose. Tantalus shall not be liable for errors contained herein or incidental consequential damages in connection with the furnishing, performance, or use of this material.
Product Description The RT-2200, a key component of the Tantalus Utility Network, is a transceiver, which is designed to collect data from the surrounding meters and deliver it from a single point, using Tantalus’ ultra-efficient burst-mode technology, which enables a large number of short data packets to be delivered at high speeds over the network. The RT-2200 sits behind a TC-2200-equipped meter and provides two-way communications between the Network Controller (utility) and the meter (customer).
RT-2200 PRODUCT SPECIFICATIONS Functional Data rate: 1600/3200 bps Mechanical interfaces: • Form S connector for installing into meter socket • Form S socket for accepting meters equipped with TC-XXXX modules Data interface: optical Radio Type: frequency agile, very narrow-band GFSK Frequency range: 220-222 MHz Channels: 200 with 5 kHz spacing RF power output: +37 dBm (5 watts) Out of band Spurious: < -65 dBc Frequency stability: < +/- 1.
Installing the RT-2200 Warning: Energized meters, meter sockets and distribution lines present the risk of electrical shock. All work on this equipment should be performed by qualified metering specialists or industrial electricians. Personnel working with this equipment should follow all utility company established operation and safety procedures. BEFORE YOU BEGIN 1. Advise the customer to turn off any sensitive electronic equipment including computers, stereos, televisions, etc. 2.
[insert diagram of hands holding RT-2200 unit in correct position] 8. Install a meter ring and seal on the unit to secure it to the meter socket.
correct channel. INSTALL METER 10. Once full two-way communication is verified, install the meter equipped with a TC-2200 into the meter socket of the RT-2200. VERIFY CONNECTION BETWEEN RT-2200 AND TC-2200 11. Make sure the TC-2200 powers up to full two-way communication by checking the LED indicator. I F THEN The TC-2200 does not power up (ie: the LED does not turn on). Remove the TC-2200 equipped meter and use another unit.