Tantalus Systems Corp.
Quick Access User Manual 1. Introduction Congratulations on purchasing the Tantalus TSC Security System – This system is so simple you shouldn’t need a user manual. 2. Using the Keypad The keys on the user keypad have functionality as described below.
an alarm if a protected door or window is opened. At the end of the exit delay the Red light stays on. 4. Disarming The System The system can be disarmed as described below. When entering through a Entry door, the keypad will beep and the entry delay will begin, reminding you to disarm the system. The keypad will display the following message… System Armed Enter Code Enter your access code. The Red light will go OFF and the keypad will beep.
Enter Code To Arm Open zones are displayed first Bypass? Press the Yes/No key to bypass the displayed zone. After selection the next zone is displayed. “Zone Name” Bypass? “O” will appear if a zone is open and not bypassed. “Zone Name” O Bypass? “Zone Name” B “B” will appear on the display to show the zone is bypassed.
Sensors? Contact installer Controller. “Zone Name” The Keypad will display the first component that may be replaced Press the No key to select the next component or press the Yes key to replace this component . Replace? to replace Keypad and Remove Component The keypad will wait two minutes for you to And Press Yes remove component and press the Yes key. The Keypad will beep. Enter New Comp # [XXXXXXXXX] # is [XXXXXXXX] Enter the new component’s Serial Number .
Loss of Clock Press Menu to adjust time or Bypass to clear message. “Device Name” AC Make sure the device is plugged in or contact installer.