AS-1 WRITER User Manual Rev.1.0 1/8 AS-1 WRITER User Manual Rev.1.0 TAKUMA SEIKO CO., LTD TEL +81-46-239-0755 FAX +81-46-239-0750 Rev.1.0 TAKUMA SEIKO CO.
AS-1 WRITER User Manual Rev.1.0 2 / 8 Contents 1 Introduction ........................................................................................................................................... 3 2 Appearance............................................................................................................................................. 3 3 Specification ..................................................................................................................................
AS-1 WRITER User Manual Rev.1.0 3 / 8 1 Introduction This address sensor unit (AS-1) is an RFID low-frequency (LF) 134.2kHz reader/writer unit for address tag for AGV (Automated Guided Vehicle) system with internal loop antenna. Address tags are used by the AGV to determine its position while driving. AS-1 has two types of the functions by factory default, AS-1 READER is an RFID reader function for use with AGV, AS-1 WRITER is an RFID writer function for writing an ID to a tag.
AS-1 WRITER User Manual Rev.1.0 4 / 8 4 Part names CN1 CN4 Rev.1.0 TAKUMA SEIKO CO.
AS-1 WRITER User Manual Rev.1.0 5 / 8 5 Interface CN1 (JST B12B-PH-K-S) Pin No.
AS-1 WRITER User Manual Rev.1.0 6 / 8 6 Operation Write operation: - Turn on the power. - Put AS-1 WRITER above the ID tag you want to write. - Set R/W switch to WRITE side. - Press the CLEAR, UP, X10, DOWN button and select the number you want to write ID address number. ― ― ― Write mode ― ― ― Wr ADRS: xxx CLEAR : ID write address to “000”. UP : ID write address to 1 increase. DOWN : ID write address to 1 decrease.
AS-1 WRITER User Manual Rev.1.0 7 / 8 Read operation: - Turn on the power. - Put AS-1 WRITER above the ID tag you want to read. - Set R/W switch to READ side. - Press the EXE button. - If reading was succeeded, ID address number will present on LCD display. ― ― ― Read mode ― ― ― Rd ADRS: xxx If reading was succeeded, EXE LED will light 100msec. If reading was failed, LCD display will present Rd ADRS: xxx . During read operation, CLEAR, UP, X10, DOWN button disabled.
AS-1 WRITER User Manual Rev.1.0 8 / 8 7 REGULATORY COMPLIANCE INFORMATION Product Name: Address sensor unit Model Name : AS-1 WRITER This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. TOMITA U.S.A INC. (HEADQUARTERS) 7801 Corporate Blvd. Ste. G, Plain City, OH. 43064 U.S.A.