User's Manual

User’s manual

The module is not for sale and the user manual integration instructions are internal

confidential manufacturing documents. For the details about this module, please refer to

the specification sheet of module.

This module should be installed in the host device according to the interface specification

(installation procedure).

This device complies with below part 15 of the FCC Rules.

Part 15 Subpart C

The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC

transmitter rules) listed on the grant, and the host product manufacturer is responsible for

compliance to any other FCC rules that apply to the host not covered by the modular

transmitter grant of certification. The final host product still requires Part 15 Subpart B

compliance testing with the modular transmitter installed.

Fine tuning of return loss etc. can be performed using a matching network. However, it is

required to check "Class1 change" and "Class2 change" which the authorities define then.

The following information must be indicated on the host device of this module;

Contains Transmitter Module FCC ID: 2AJE9MR-2400MA

Contains FCC ID: 2AJE9MR-2400MA

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired

operation.

*If it is difficult to describe this statement on the host product due to the size, please

describe in the User's manual.

The following statements must be described on the user manual of the host device of this

module;

FCC CAUTION

Changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

PAGE 1
User’s manual The module is not for sale and the user manual integration instructions are internal confidential manufacturing documents. For the details about this module, please refer to the specification sheet of module. This module should be installed in the host device according to the interface specification (installation procedure). This device complies with below part 15 of the FCC Rules. Part 15 Subpart C The modular transmitter is only FCC authorized for the specific rule parts (i.e.
PAGE 2
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment has very low levels of RF energy that is deemed to comply without testing of specific absorption ratio (SAR).