Installation Instructions

Note to users in the United States of America

Notice:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

･Reorient or relocate the receiving antenna.

･Increase the separation between the equipment and receiver.

･Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

･Consult the dealer or an experienced radio/TV technician for help.

The product with the Wireless device has been tested to SAR and complies with

FCC exposure requirements for portable devices.The SAR test has

been done at distance of 0cm from the body.

Warning:

Changes or modifications not expressly approved by the party responsible for compliance could void the

user’s authority to operate the equipment.

Caution:

The available scientific evidence does not show that any health problems are associated with using low power

wireless devices. There is no proof, however, that these low power wireless devices are absolutely safe. Low

power

Wireless devices emit low levels of radio frequency energy (RF) in the microwave range while being used.

Whereas

high levels of RF can produce health effects (by heating tissue), exposure of low-level RF that does not produce

heating effects causes no known adverse health effects. Many studies of low-level RF exposures have not found

any biological effects. Some studies have suggested that some biological effects might occur, but such findings

have

not been confirmed by additional research. Operational Panel with RYYWYSAAVDX7 has been tested and

found to comply with FCC

radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF)

Exposure Guidelines in Supplement C to OET65.

PAGE 1
Note to users in the United States of America Notice: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.