Taiyuan Edge® R/C Consumer Service We want to assist you! DO NOT RETURN THE PRODUCT TO THE STORE! Log on: Click “Service” at www.taiyoedge.com E-mail: TOLL-FREE CONSUMER HELPLINE 433-4372) OWNER'S MANUAL important! Please read your UFX™ Owner's Manual all the way through before operating your vehicle. Contains important information—keep for future reference. ASSEMBLY REQUIRED.
Transmitter Battery 1. Slide open BATTERY DOOR on back of TRANSMITTER (Fig, 7). 2. insert a fresh, new 8-VOLT ALKALINE BATTERY with the polarity as shown on bottom of battery compartment {Fig 8}. IMPORTANT: OBSERVE BATTERY POLARITY (DIRECTION, + AND | 3. Hold battery in place with thumb and slide battery door all the way closed. (Fig. 8). Assemble Charger Base 1. Press POSTS on bottom of LAUNCHER CONE into HOLES on top of CHARGER BASE. {Fig.
Charging Facts and Tips 1. Always charge UFX completely and immediately before flight. 2. It is not necessary to remove the “D* cell batteries from Charger Base when using CAR ADAPTER power. 3. When using “12V" position, if GREEN LED charging indicator does not fight, recheck connections and refer to cat's owner's manual to see if ignition key needs to be in “Accessory” or other position to turn on power outlet. 4. UFX POWER HUB has an automatic battery temperature sensing system.
Transmitter Control of Flight {con't} After landing, always wait for the propellers to stop completely before handling UFX. Always turn the power switch on UFX to the OFF position as soon as the propellers stop. Be sure to descend quickly if your UFX begins to drift into areas that [ET] are not safe for fining. Jy Like hot air ballooning or gliding, flights should be planned sa that UFX can travel downwind before landing safely inside the safe, open flying area.
Replace Blue Motor Wing 1. Disconnect plug and remove the damaged wing. You will need to remove the motor and propeller assembly and then install it on the replacement wing. First, remove propeller as above. 2. Follow steps 2 and 3 above to free the wire. (Fig. 17} 3. Use a small Philips screwdriver to remove the screws holding the MOTOR COWLING to the top of the wing and remove the COWLING, 4, At the same time, pull MOTOR & MOUNT from top of wing and SKID from bottom.
Assembly Required Remove all UFX components the packaging and lay them out for identification, (Fig. 1} Note: Be careful when unwrapping wire ties or other packaging material to avoid damaging pans. Don't use any sharp tool that could cut or score wings. Save the packaging tray to store disassembled UFX when not in use. Attaching Wings 1. Study Fig. 2 carefully, It shows which wings go where, and also the correct angle to "approach” the POWER HUB with gate wing. Note POWER SWITCH is in “CHARGE position. 2.