TB7100 base station Installation and Operation Manual MBA-00005-04 Issue 4 December 2004
Tait Contact Information Tait Radio Communications http:// www.taitworld.com Corporate Head Office New Zealand Tait North Asia Tait Electronics Ltd P.O. Box 1645 Christchurch New Zealand E-mail: info@taitworld.com Website: http://www.taitworld.com Technical Support: E-mail: support@taitworld.com Website: http://support.taitworld.com Tait North America Regional Head Office - United States of America Tait North America Inc. E-mail: usa@taitworld.
Contents Preface 1 Description 2 Controls 3 Configuration 4 Installation 5 Connection 6 Functional Description 7 Circuit Description TB7100 Installation and Operation Manual © Tait Electronics Limited December 2004 3
Preface Scope of Manual Welcome to the TB7100 base station Installation and Operation Manual. This manual provides information on installing and operating the TB7100 hardware. Enquiries and Comments If you have any enquiries regarding this manual, or any comments, suggestions and notifications of errors, please contact Technical Support (refer to “Tait Contact Information” on page 2).
Installation This chapter describes how to install the TB7100 base station in a standard 19 inch rack or cabinet. It also provides some general information on safety precautions and site requirements. We recommend that you read the entire chapter before beginning the installation. 1.1 Personal Safety 1.1.1 Explosive Environments Warning!! 1.1.2 Do not operate TB7100 base station equipment near electrical blasting caps or in an explosive atmosphere.
Figure 1.1 Typical antistatic bench set-up conductive wrist strap dissipative rubber bench mat common point ground (building ground or mains ground via 1M ohm series resistor) 1.2.2 Antenna Load The TB7100 base station equipment has been designed to operate safely under a wide range of antenna loading conditions. However, we strongly recommend that the transmitter should always be operated with a suitable load to prevent damage to the transmitter output power stage. 1.2.
1.3.2 FCC Compliance This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. 1.3.3 Unauthorised Modifications Any modifications you make to this equipment which are not authorised by Tait Electronics Ltd may invalidate your compliance authority’s approval to operate the equipment. 1.4 Environmental Conditions 1.4.
Installation TB7100 Installation and Operation Manual © Tait Electronics Limited December 2004
Controls and Connections Figure 2.
Controls and Connections TB7100 Installation and Operation Manual © Tait Electronics Limited December 2004