User's Manual

ManualsBrandsTactical Electronics ManualsElectronicsVHF TRANSCEIVER

T100 TRANSCEIVER

OPERATING INSTRUCTIONS

1892 1158

96.00

(3.8")

3.40 (0.134")

diameter in

4 places

FIXING CENTRES FOR ENCLOSURE

(PLAN VIEW)

Dimensions in mm (inches)

D TYPE

RF CONNECTOR

These operating instructions are intended to provide the user with sufficient information to

install and operate the unit correctly.

The Tactical Electronics T100 transceiver is intended to fulfil the numerous OEM applications

by virtue of its highly reliable design , miniature size, and quality manufacture.

MOUNTING DETAILS

The T100 is intended to fit easily and with minimum space requirements into the user's own

equipment housing. The complete module is housed within a tin-plated enclosure and is

secured by means of four 10mm self-tapping sheet metal screws which locate in the four corners

through the lower screening cover. DO NOT overtighten these screws during assembly.

Tactical Electronics Corporation

Summary of content (5 pages)

PAGE 1
Tactical Electronics Corporation T100 TRANSCEIVER OPERATING INSTRUCTIONS 1892 1158 These operating instructions are intended to provide the user with sufficient information to install and operate the unit correctly. The Tactical Electronics T100 transceiver is intended to fulfil the numerous OEM applications by virtue of its highly reliable design , miniature size, and quality manufacture.
PAGE 2
CONNECTION The radio antenna connects by means of a BNC coaxial connector. All other connections to the T100 transceiver are made using a standard 9-way D type connector as detailed in the table below. PIN NAME 1 MOD I/P FUNCTION Modulation input REMARKS To transmitter; Analog (750mV p-p for nominal deviation) or TTL/CMOS compatible (factory set) 2 RX O/P Receiver Output Analog (350mV p-p) or 5V CMOS levels, high ( +5V) when no signal present (factory set) 3 T bX bE b transmit enable HIGH >2.
PAGE 3
OPTIONS Frequency and Channel spacing The T100 is available in both 12.5 and 25kHz channel spacing variants within the following frequency bands: 135 - 140 MHz 150 - 180 MHz 180 - 210 MHz RF connection As well as the standard BNC coaxial connector, the T100 is also available with a SMB or flying lead RF connection. Contact Tactical Electronics Corporation for details. Transmit Power The maximum transmit power of the unit is 2W.
PAGE 4
RUNNING THE SOFTWARE Please note that mouse operation is not supported with this program 1. Connect the T100 transceiver to a suitable supply and to the PC using the programming adaptor. 2. Insert the TLSPRG disk into drive A and type: A:TLSPRG 3. 4. The user is then prompted to enter the serial port number of his PC which is used to communicate with the TX00 transmitter. Enter 1 or 2. Note: Do not select the port with the mouse connected as this will cause the program to run incorrectly.
PAGE 5
TECHNICAL SPECIFICATION Frequency of operation Frequency bands : : Switching bandwidth Channel spacing Number of RF channels : : : RF output power Frequency stability Supply voltage : : : 135 to 210MHz (other frequency bands available) 135 - 140 MHz 150 - 180 MHz 180 - 210 MHz 3MHz within frequency bands 12.5kHz (25kHz available as an option) One, set by PIC micro controller changed by serial channel select 2W nominal at 12V DC ±2.5ppm over temperature range (12.