C4D-4G4USAB_V7+ - INSTALLATION GUIDE V 1.
Table of contents Preface ............................................................................................ 3 Warnings and notices ...............................................................................3 FCC Regulations ..........................................................................3 FCC RF Exposure Information (SAR) .................................................... 4 1. Hardware features ................................................................................5 2.
Preface The information contained in this installation guide is subject to changes in order to improve the reliability, design or features without prior notice. Mobile Devices Ingénierie reserves the right to make changes in the content without obligation to notify any person or organisation of such changes or improvements.
FCC RF Exposure Information (SAR) This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the United States. During SAR testing, this device is set to transmit at its highest certified power level in all tested frequency bands, and placed in positions that simulate RF exposure in usage near the body with the separation of 15 mm.
1. Hardware features OBD Dongle Performance Power supply Communication WLAN Positioning Interface & Telematics features Environmental Processor RAM NAND Flash External power supply range External voltage measurement Li-pol battery Modem Modem antenna SIM Wifi Bluetooth GNSS receiver GNSS antenna IMU OBD protocols CAN interface Buttons Leds Connectors Operating temperature Dimensions Cortex A5 - 500MHz 1 Gbytes 2 Gbytes 8-18V ● 270mAh 4G Cat.4 module (LE910C4-NF) Internal Micro SIM clot WiFi 802.
2. Hardware description 2.1. External view 1 : OBD connector 2 : Reset button 3 : Power led 4 : Signal led 4 2 3 1 2.2.
2.3 OBD connector pin out Pin # 1 2 3 4 5 6 7 8 10 11 14 15 16 Comment OEM specific J1850+ (PWM/VPW) OEM specific Chassis ground Signal ground CAN High K line OEM specific J1850- (PWM) OEM specific CAN low L line Battery voltage 2.4 OBD adapter wires This adapter is only used to connect the OBD to a computer (laptop/desktop).
3. Preparing/installing the device Those operations may need the use of specific tools like : - TORX pattern TX5 screwdriver for the screw. - Small slotted screwdriver to remove the cover. - Thin tweezers to insert/remove the SIM card. 3.1. Open the device Remove the two screw using TX5 screwdriver Use slotted screwdriver to pop-out the top cover on both side. Slide the top cover heading back to remove it.
Move apart the side of the device and pull the corner of the back cover out of his spot Pull the back cover on the rear and remove the back cover.
3.2. Insert the SIM card The SIM card slot is located between the two electronic cards. Insert the card with contact on bottom into the slot and push it as far as it will go.
3.3. Properly close the device First, insert the back cover beginning with corner near the power led. Second, Move apart the side of the device and push the back cover on the spot Third, insert the top cover beginning with the back and push on top to clip-on the top cover Finally, place the screw.
3.4. Install the OBD Dongle Connect the OBD Dongle on your vehicle OBD connector. 4. LED sequences The Dongle has a two-coloured LED, green and red. When both colours are brightened, you can see an orange light. Sequence Green LED Meaning No Modem /No GNSS No Modem /Fix GNSS Modem OK /No GNSS Modem OK /Fix GNSS 3 times (50ms ON/100ms OFF) 3550ms OFF 2 times (50ms ON/100ms OFF) 3700ms OFF 1 time (50ms ON/100ms OFF) 3850ms OFF 2000ms ON 2000ms OFF Sequence Dongle OFF Red LED Meaning OFF Ext.
