DJI Motion Controller (Model: FC7BMC) Quick Start Guide v1.
Introduction 1. Battery Level Indicator 2. Take‐off/Landing Button (non‐M mode) Lock/Unlock Button (M mode) 3. Flight Mode Switch 4. Flight Pause Button 5. Gimbal Slider 6. Shutter/Record Button 7. Throttle Trigger 8. Lanyard Attachment 9. USB‐C‐Port 10.
Charging Checking Battery Levels and Powering On/Off Press once to check the battery level. Press, then press and hold to turn on/off. Activation When the remote controller is powered on, connect the USB‐C port to your computer and run DJI ASSISTANT 2 for activation. Linking 1) 2) Press the link button on the goggles. The goggles will beep continually. Press and hold the power button of the aircraft until the battery level indicator blinks in sequence.
3) TThe battery leevel indicator of the aircraft turns solid and displays the battery llevel. The gogggles sttop beeping when w they arre successfullly linked and the video dissplay is normaal. 1) Press and hold P d the power button b of thee aircraft until the battery level indicato or blinks in sequence. P Press and hold d the power button b of thee remote conttroller until itt beeps continually and th he b battery level indicator blinks in sequencce.
4. Press and hold the Shutter/Record Button to switch the shooting mode. Tap to take a photo or to start or stop recording a video.
Speccification ns Model FC C7BMC Weigh ht 165g Operaating Frequecy 2.400‐2.4835 GHz;5.725‐‐5.850 GHz Max Transmission T Distance (unobstructed, free f of interfeerence) 10 km (FCC); 6 km (CE/SRR RC/MIC) Transm mitter Power (EIRP) 2.4 GHz: ≤29 dBm (FCC ), ≤20 dBmm(CE/SRRC/M MIC) 5.8 GHz: ≤31 1.
Compliance Information FCC ComplianceNotice This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co‐located or operating in conjunction with any other antenna or transmitter.The portable device is designed to meet the requirements for exposure to radio waves established by the ISED. These requirements set a SAR limit of 4.0 W/kg averaged over ten gram of tissue.