DAT AL I N K 3 Quick Start Guide V1.
Disclaimer Congratulations on purchasing your new DJI™ product. The information in this document affects your safety and your legal rights and responsibilities. Read this entire document carefully to ensure proper configuration before use. Failure to read and follow instructions and warnings in this document may result in serious injury to yourself or others, damage to your DJI product, or damage to other objects in the vicinity.
or GS Pro* apps, users will be able to see and change live parameters, completing complex tasks more easily. The remote controller boosts a maximum working time of 24 hours*. * The remote controller is able to reach its maximum transmission distance SRRC in a wide open area with no Electro‐Magnetic interference, and at an altitude of about 100 meters. **Refer to the Specifications for details on supported DJI flight controller series. ***Coming soon Ground System (C1 Remote Controller) 1. 1.
Air System 1. Firmware Update Port Micro USB 2. CAN Port 5. Linking Button 6. Antenna Ports 7. Power Port 3. UART Port 8. DBUS/SBUS Port 1. Downloading MG‐FE or GS Pro Scan the QR code below or visit the App Store to download DJI's MG‐FE or GS Pro apps. MG‐FE GS Pro *DJI MG‐FE only supports some mobile devices with Android 4.4 or above. Refer to Specifications for more details. GS Pro is only supported on the iPad.
2. Battery Level and Charging Press the power button once to check the battery level. Press and hold for 2 seconds to power on the remote controller. Low to High Please use the included charger to charge the remote controller, when the power level is low. It is recommended to charge the remote controller with the power off. Please recharge the battery at least every three months to ensure it remains in a fully charged state – the battery will deplete when stored for long periods.
Unfold the remote controller a. Press the clamp on the mobile device holder. b. Adjust the mobile device hold to tighten the mobile device. c. Connect the mobile device and the remote controller via a Micro USB cable. Strong Weak 5. Flight DJI's series of Flight Controllers have a default flight mode is known as Mode 2. The left stick controls the aircraft's altitude and heading, while the right stick controls forward, backward, and left and right movements.
Combination stick command to start/stop the motors Push the left stick up slowly for take off Pull the left stick down slowly until you touch the ground. Hold down for a few seconds to stop the motors Refer to Datalink 3 User Manual for more operation information. 6.
Ground d System C1 C Remote Controller • Model: DLG G30A • • • • Dimensionss 182 172 71 mm Charging Teemperature Range: 32° to 104° F 0° to 40° C Built‐in batttery: 6000m mAh LiPo 2S Operating V Voltage: 1.2A A @7.4V Air Systtem • • • • • Model: DLA A30A Dimensionss antennas excluded : 50.6 5 35 10.7 mm Weight anttennas exclu uded : 23 g Operating V Voltage: 8V~ ~30V Operating T Temperaturee Range: 14° to 122° F ‐10° to 50°° C GPS Mo odule • • • • Satellite Possitioning Systems: GPS//GLONASS Max.
FCC Compliance Notice This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
