User's Manual

Table Of Contents

WM Assistant for ios

Step1Assemble the LED Bluetooth Module

ANT

The LED Bluetooth Moduleis necessary if you are using the WM Assistant. This module

is only for the ios equipment, not android equipment. It is Operating Temperature range is

from -5°C to +50°C.Please refer to the Assembly & Configuration -> Step1 Assembly to

attach the module.

This module has a USB interface for configuration and firmware upgrades by PC

connection. The built-in Bluetooth is for wireless communication between the autopilot

system and mobile equipment, with a maximum communication distance of 50m.

Step2WM Assistant Installation

Please search the WM Assistant from the App Store by your ios device, download and install it.

Step3Parameter Configuration Procedures

1. Prepare an iosequipment that supports Bluetooth 4.0, and turn on the Bluetooth.

2. Switch on the transmitter first, power on the autopilot system, and then run the WM Assistant. The

LED blinks Purple and Yellow alternately (

) when the WM Assistant is connected to the autopilot

system. Make sure your ios device is connected to the Internet for the first time you use, to register

account. And also you can login with the PC assistant account.

3. Run the Assistant Software. Set up the name and password for the autopilot system according to the

App start.

4. Observe the indicators on the left bottom of the software. (

They are the connection indicator

and communication indicator in order.)On the WM Assistant, if the communication indicator is on,

please double check the connections and driver installation; otherwise if the indicator is blinking, go

to next step.

5. Select the “Basic” option. Please follow step-by-step for your first-time-configuration.Basic

configuration is necessary. Click the icon

to get the configuration details.

6. You can click the “Advanced” option for more parameter settings.Advanced setting is optional. There

are Motor, Enhanced Fail-Safe, Intelligent Orientation Control (IOC), Gimbal, Low-voltage Alarm,

Flight Limits, etc.

7. Select Viewer and check all parameters.

8. Select “More” to obtain more details. Including: (Parameter)Import-Export, Restore Factory Settings,

Account, Main Controller List, Information( including Hardware ID, IMU, Loader, Firmware, SN and

Functions Activation Status), Rate WM Assistant, Feedback, About(Help Document, Disclaimer)

PAGE 1
WM Assistant for ios Step1Assemble the LED Bluetooth Module The LED Bluetooth Moduleis necessary if you are using the WM Assistant. This module is only for the ios equipment, not android equipment. It is Operating Temperature range is ANT from -5°C to +50°C.Please refer to the Assembly & Configuration -> Step1 Assembly to attach the module. This module has a USB interface for configuration and firmware upgrades by PC connection.
PAGE 2
iosEquipment List  iPhone 4s  iPhone 5  iPod touch5  iPad mini  iPad 3  iPad 4 Refer to the WM Assistant for more details. Step4Flying Test Procedures 1. Slide the switch from OFF to ON, to start the main controller output according to the following chart. Switch of the main controller output is OFF Switch of the main controller output isON 2. Start the motors. 3. The “View” page shows the relative parameters real-time when flying. 4.
PAGE 3
CE Statement： Due to the used enclosure material, the devices shall only be connected to a USB. Interface of version 2.0 or higher. The connection to so called power USB is prohibited. Hereby, SZ DJI TECHNOLOGY CO.,LTD declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. FCC Statement： This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.