User's Guide

ManualsBrandsSZ DJI Osmo Technology ManualsElectronicsRonin RavenEye Image Transmission System

Ronin RavenEye Image Transmission

SystemUserGuide

Model:WV‐001

Introduction

The Ronin RavenEye Image Transmission System is used to transmitthe image signal to the DJI

RS/RS2/RSC/RSC2,mobilephoneandmonitor,andmoredevice,itiseasytochecktheliveview

remotely.

1. An

tenna

Transmitthewirelesssignal.

2. ReservedLED

Reserved.

3. Power/CommunicationPort(USB‐C)

Forchargingandcommunication.

4. HDMIPort

Forconnectingthecamera’sHDMIport.

5. RSSCameraControlPort(USB‐C)

Forconnectingtothegimbal’scameracontrolport.

6. BatteryLevelIndicators

Indicatesthebatterylevel.

7. St

atusLED

Indicatesthesystemstatus.

8. PowerButton

Press and hold to power on/off. Press four times to restore the default Wi‐Fi password to

12345678.

Summary of content (4 pages)

PAGE 1
Ronin RavenEye Image Transmission System User Guide Model: WV‐001 Introduction The Ronin RavenEye Image Transmission System is used to transmitthe image signal to the DJI RS/RS 2/RS C/RSC 2, mobile phone and monitor, and more device, it is easy to check the live view remotely. 1. Antenna Transmit the wireless signal. 2. Reserved LED Reserved. 3. Power /Communication Port (USB‐C) For charging and communication. 4. HDMIPort For connecting the camera’s HDMI port. 5.
PAGE 2
9. Cold Shoe For connecting to the gimbal or camera. Installation 1. Attach the Image Transmission System to the gimbal or camera. 2. Connect the HDMI port to the camera’s HDMI port using the provided HDMI cable according to the camera type. 3. Connect the communication port to the gimbal’s Image Transmission port using the provided USB‐C to USB‐C cable. 4. Connect the camera control port to the gimbal’s RSS camera control port. 5. Balance the camera after installation.
PAGE 3
Whenused with the DJI RS/DJI RSC, ActiveTrack and camera control are unavailable, other operations are the same. When used with the camera without a gimbal, use the mobile phone to control the camera and display the camera view.
PAGE 4
FCC/ISEDC Compliance Notice This device complies with Part 15 of the FCC/ISEDC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.