m010 intervac vacport manual 9.3

ManualsBrandsSystemair ManualsResidential systemsVac pan LED, white

RECORD THIS INFORMATION FOR

FUTURE REFERENCES

MODEL NUMBER _______________________

DATE OF PURCHASE ___________________

PLACE OF PURCHASE__________________

Manual # M010 Date: 01-2015

INSTALLATION AND OPERATING MANUAL

MODEL A900 with LED

MODEL A910 without LED

IF YOU SHOULD HAVE ANY QUESTIONS OR EXPERIENCE A PROBLEM WITH YOUR

INTERVAC PRODUCT,

PLEASE CALL OUR CUSTOMER SERVICE DEPT. AT: 1-888-499-1925

DO NOT RETURN THIS PRODUCT TO THE STORE OR DEALER

This unit should be installed by a qualified technician.

InterVac Design Corp.

Phone 772-463-1400 • USA & Canada toll free 888-499-1925

www. .com •

2939 SW 42nd Avenue, Palm City, FL 34990

intervacdesign e-mail: intervac@intervacdesign.com

Summary of content (4 pages)

PAGE 1
By RECORD THIS INFORMATION FOR FUTURE REFERENCES MODEL NUMBER _______________________ DATE OF PURCHASE ___________________ PLACE OF PURCHASE__________________ Manual # M010 Date: 01-2015 INSTALLATION AND OPERATING MANUAL MODEL A900 with LED MODEL A910 without LED IF YOU SHOULD HAVE ANY QUESTIONS OR EXPERIENCE A PROBLEM WITH YOUR INTERVAC PRODUCT, DO NOT RETURN THIS PRODUCT TO THE STORE OR DEALER PLEASE CALL OUR CUSTOMER SERVICE DEPT.
PAGE 2
ELECTRICAL REQUIREMENTS: The low voltage Control Wires from your Central Vacuum Cleaner have mostly an output of 24volt AC. Note: some Central Vacuums have 24volt DC output. If your vacuum does not start --- just reverse the 2 wires at the wire nuts. (reverse the polarity). Installation: into a kitchen cabinet kick-board or room base board flush with the floor.
PAGE 3
Connecting the VacPort to your Central Vacuum top view of VacPort LED Circuit Board 24 Volt Pigtail Wire 1) elbow with pipe coupling 2) pipe coupling 3) flex-hose with threaded coupling into pipe coupling Or hose Please Note: The connection to the VacPort should be flexible enough so that you can pull the FLEXIBLE HOSE and central vacuums Low Voltage Wires out of the wall and connect both to the VacPort outside the wall.
PAGE 4
ATTACHING VACPORT TO AN EXISTING REMOTE INSTALLED VACUUM 3 3 1 3 5 4 2 #1 Elbow fitting, does not need to be installed. Used only in tight spaces. #2 Existing 2” diameter Flex-Hose or Vacuum Pipe. If you have vacuum pipe installed , run the pipe straight into the “T” (#4) #3 Black Threaded Coupling, 4 supplied. This coupling is screwed counter clockwise into the 2” Flex-Hose, the other end attaches to a pipe fitting with a twist and push.