MOUNTING INSTRUCTION TG ROOF CURB
1 (3)
TG Roof curb
The product is manufactured from galvanised sheet steel, insulated with rockwool and a
perforated inner sheet. The product is prepared with cable glands and a integrated cable
hose for leading the electric cables safely on the inside of the roof curb.
Mounting brackets are enclosed to fit the product to the pitched roof.
Note:
Verify that ceiling joists have sufficient bearing capacity to hold the roof fan
and the roof curb.
Note:
Obey local laws and regulations for installation of the roof curb on the roof.
To install the mounting bracket
c/c
Fig. 1
1. Attach the mounting brackets on each side of the roof curb.
2. Start with one screw in the middle of the mounting bracket. Use sheet metal screws,
ø6,3 mm.
3. Use a spirit level to make sure the roof curb is horizontal.
4. Attach the mounting brackets with further screws. Max c/c distance 200 mm.
Systemair Sverige AB · Industrivägen 3, SE-739 30 Skinnskatteberg, Sweden
Phone +46 222 440 00 Fax +46 222 440 99 -en_GB- v001