ODS for Topvex SR units Installation instructions Document in original language | 135577 · A003 GB
© Copyright Systemair AB All rights reserved E&OE Systemair AB reserves the rights to alter their products without notice. This also applies to products already ordered, as long as it does not affect the previously agreed specifications.
Contents 1 2 Warnings.......................................................1 Mounting ODS ................................................1 2.1 Topvex SR03–06 ....................................1 2.2 Topvex SR09–11 ....................................
Warnings | 1 Warnings Danger • Make sure that the mains power supply to the unit is disconnected before performing any maintenance or electrical work! • All electrical connections must be carried out by an authorized installer and in accordance with local rules and regulations. Warning • The door handles are only intended to be used during the installation and service. These must be removed before the unit is put into operation to ensure the required level of safety for the unit.
2 | Mounting ODS 3 Make sure the levelling is done, each foot shall be supported. Push the ODS against the Topvex unit’s exhaust air side. Lead cabling from the damper along the inner wall of the ODS and through the cable glands. (Fix cables if necessary with cable strap, not included.) 4 Mount the brackets to secure the ODS to the Topvex unit and attach each of the brackets with two M5x16 allen bolts.
Mounting ODS | 6 Place the middle roof brackets in the slot between the frame and the units door. 7 Place the roof part on the ODS first (1). Note: Note the difference between the roof parts! See step 9. 8 Attach the roof with 4 sheet tracs in each corner.
4 | Mounting ODS 9 Part two of the roof cover the first part. Attach with 2 sheet tracs.
Mounting ODS | 2.2 Topvex SR09–11 1 Mount the offset parts on the exhaust air side. 2 Make sure the levelling is done, each foot shall be supported. Mount each damper on the offset parts with 4 M8x20 hexbolts and M8 nuts. Note: Images show left hand unit installation. 3 Mount the mounting brackets in each corner on the unit. Use the bracket at a template and drill holes. Fastened with sheet tracs. 4 Fastened threaded M10x70 bolts in each corner inside the ODS.
6 | Mounting ODS 6 Secure the bolt with a wrench inside the ODS. 7 Mount the corner brackets for the roof. Fastened the corners by bringing the bottom edge in the area between the door and the frame. Note: For Topvex SR09–11 no corners shall be broken. 8 Mount the roof for Topvex SR09–11 as for Topvex SR03–06 (step 6 to step 9).
135577 | A003
Phone +46 222 440 00 Fax +46 222 440 99 www.systemair.