User Manual

Thank you for choosing SYNCO product.
Please read this manual carefully before use and follow all instructions
mentioned herein.
Microphone G1T/ G1L
User Manual
Caring For Your SYNCO Product
Package List
Product Instruction
Operations
Please keep the product in a dry, clean, dust-free environment.
Keep corrosive chemicals, liquids and heat source away from the
product to prevent mechanics damage.
Use only a soft and dry cloth for cleaning the product.
Malfunction may be caused by dropping, impact of external force.
Do not attempt to disassemble the product. Doing so voids warranty.
Please have the product checked or repaired by authorized
technicians if any malfunctions happened.
Failure to follow all the instructions may result in mechanics damage.
Warranty does not apply to human errors.
TX Transmitter x1 RX Receiver (Type-C or
Lightning Connector) x1
Carrying Bag x1
Mic Windshield x1 Charging Cable x1
TX Transmitter
RX Receiver
Indicator — TX Transmitter
Indicator — RX Receiver
① External Mic Input
② USB-C Port
③ Power/ Mute
④ Reset(Help with Eject Pin)
⑤ Low Cut
① Vocal E󽗈ects
② Pairing/ Gain Control
③ USB-C Port
⑥ Pairing
⑦ Built-in Mic
⑧ Pocket Clip
⑨ Pairing/ Muting Indicator
⑩ Power Indicator
④ Detachable Connector
⑤ 3.5mm In-Ear Monitoring Jack
⑥ Pairing Indicator
TX
1.Power/ Mute
2.Charging
3.External Mic Input
4.Mic Windshield & Device Installation
5.Reset
6.Low Cut
7.Pairing
Long Press 3s: turn on/o󽗈 the system
Short Press: mute/unmute the
microphone
5V/2A;
Please fully charge the product
before use with USB-C charging
cable.
Slow 󽗊ashes System unpaired
Slow 󽗊ashes
Keeps on
System unpaired /
System paired Vocal e󽗈ects on
/
Pairing/ Muting Indicator Power Indicator
Pairing Indicator
Fast 󽗊ashes System pairing
Fast 󽗊ashes System pairing /
/
/
Keeps on System paired
Low cut on
Muting
Fast 󽗊ashes
twice
Short Press: 150Hz Low Cut On
Short Press again: Low Cut O󽗈
Gently poke the pin into Reset for 3 seconds to
restore factory defaults.
The system will pair automatically after power on.
Manual pairing: long press the pairing button on the TX and RX for 3
seconds
TRS Mic Only
(Note: When using an external mic, please insert it
into the mic input properly.)
Eject Pin
Long press for 3s
TX RX
TX
/
/
/
1.Low battery;
2.Charging, and is o󽗈
after fully charged
RX
1.Vocal E󽗈ects
Short press to switch sound e󽗈ects: Original -
Studio FX - KTV FX - Voice Ampli󽗉cation - EDM
(Electronic Dance Music) - Baby FX - Male to
Female - Female to Male - Monster FX
3.USB-C Port
For charging phone device
The system will pair automatically
after power on.
2.Pairing/ Gain Control
4.Detachable Connector
G1T: Type-C connector
G1L: Lightning connector
Extra Type-C or Lightning connector is available separately to adapt RX
to more phone devices.
Manual pairing: long press the pairing button on the TX
and RX for 3 seconds
Gain Control: 0-3 Level
Each short press increases gain by one level.
Long press for 3s
TX RX