Certification Exhibit FCC ID: U9O-SS200 IC: 7084A-SS200 FCC Rule Part: 15.247 IC Radio Standards Specification: RSS-210 ACS Report Number: 10-0296.W06.11.A Manufacturer: Synapse Wireless, Inc. Model: SS200 Manual 5015 B.U.
SNAP Stick User Guide Wireless Technology to Control and Monitor Anything from Anywhere ™ Synapse Wireless, Inc. 500 Discovery Drive Huntsville, Alabama 35806 256.852.7888 www.synapse-wireless.
Copyright © 2011 Synapse Wireless, Inc., All Rights Reserved. All Synapse products are patent pending. Synapse logo, SNAP, and Portal are all registered trademarks of Synapse Wireless, Inc. 500 Discovery Drive Huntsville, Alabama 35806 256.852.7888 These devices comply with part 15 of the FCC rules.
About Your SNAP Stick USB Wireless Adapter SNAP Stick USB (SS200-001) The SNAP Stick USB device is used to enable a PC to communicate with local SNAP nodes. This device, based on the ATMEL ATmega128RFA1 hardware, is a USB dongle, about the size of a thumb drive. It is designed to act as a bridge between Synapse’s management tool, called Portal, or Synapse’s Internet connection capability, called SNAP Connect, and your other SNAP nodes.
LED State Pin 5 Pin 6 Off High (True) High (True) Red Low (False) High (True) Green High (True) Low (False) Amber Low (False) Low (False) The SS200 includes an internal power amplifier. It also has a 32 kHz crystal, so for most efficient sleep state, you should use sleep mode 1. Note that there is no way to trigger an external wakeup signal to the device, so you should be careful to only use timed sleep.
Troubleshooting In the realm of wireless communications, many factors can affect reliable data communications. This section lists a number of known factors and possible remedies. If your question is not adequately answered here, visit the SNAP support forum on the Synapse Wireless website where you can post a question and interact with other SNAP users. The SNAP Support forum can be accessed at: forums.synapse-wireless.com/forumdisplay.
Regulatory Information and Certifications RF exposure statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment may operate in direct contact with the body of the user under normal operating conditions. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. FCC certifications and regulatory information (USA only) FCC PART 15 CLASS B These devices comply with part 15 of the FCC rules.
Declaration of Conformity (In accordance with FCC 96-208 and 95-19) Manufacturer’s Name: Headquarters: Synapse Wireless, Inc. 500 Discovery Drive Huntsville, Al 35806 Synapse Wireless, Inc.