Certification Exhibit FCC ID: U9O-HCTAG FCC Rule Part: 15.249 ACS Project Number: 13-0253 Manufacturer: Synapse Wireless Inc. Model: HCTAG Manual 5015 B.U.
DATA SHEET HCTAG Series Model Number: HCTAG Part Numbers: HCTAG-ST001 Document Revision v1.0 © 2013 Synapse, All Rights Reserved All Synapse products are patented or patent pending Specifications are subject to change without notice – confirm that data is current Synapse, the Synapse logo, SNAP, and Portal are all registered trademarks of Synapse Wireless, Inc.
Page 2 of 7 ∙ ©2013 Synapse Wireless, Inc. ∙ Document Number 430157-01A ∙ 500 Discovery Drive, Huntsville, AL 35806 ∙ 256-852-7888 HCTAG Data Sheet ∙ synapse-wireless.
Table of Contents 1. HCTAG OEM Device Overview............................................................................................ 4 Specifications.............................................................................................................................. 5 Electrical Characteristics ............................................................................................................ 5 2. Agency Certifications ............................................................
1. HCTAG OEM Device Overview The HCTAG device is an IEEE 802.15.4, low-power, highly-reliable solution to embedded wireless control and monitoring network needs that require high data rates. The HCTAG embeds Synapse’s SNAP OS, the industry’s first Internet-enabled, wireless mesh network operating system into the Atmel ATmega128RFA1 single-chip AVR® microcontroller with an integrated transceiver that delivers up to 2Mbits/sec.
16Mhz XTAL 2.4Ghz IEEE 802.15.4 Atmel ATmega128RFA1 Microcontroller Peripherals Balun F-Antenna 32.768kHz XTAL Figure 1.0 Block diagram showing the major subsystems comprising the HCTAG Specifications Table 1.0 HCTAG Specifications Transmit Power Output RF Data Rate Receiver Sensitivity Supply Voltage Transmit Current (Typ@3.0V) Idle/Receive Current (Typ@3.0V) Power-down Current (Typ@3.
2. Agency Certifications United States (FCC) WARNING: The HCTAG modules have been tested by the FCC for use with other products without further certification (as per FCC Section 2.1091). Changes or modifications to this device not expressly approved by Synapse Wireless Inc. could void the user’s authority to operate the equipment. The HCTAG modules comply with Part 15 of the FCC rules and regulations. Compliance with the labeling requirements, FCC notices and antenna usage guidelines is required.
modifications to this device not expressly approved by Synapse Wireless Inc. could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.