AIM2 INSTALLATION INSTRUCTIONS Syn-Tech Systems, Inc.
WARNING: AIM2 equipment is only intended to be used with the AIM2 system. Do not connect any AIM2 part to any non-AIM2 part unless specified in these instructions. Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate this device. NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
AIM2 vehicle installations for vehicles using the OBD port. Step 1: Select mounting location for the AIM2 Main Module. Recommended locations are under the dash or under the seat that is on the same side of the vehicle as the fuel tank’s filler neck. Keep in mind the distance from the power source and grounding requirements in relation to the mounting location. Note: The AIM2 Main Module should be mounted out of harms way but, accessible for service or troubleshooting.
Step 9: Attach RFID Interface Module to Filler Neck Ring cable and RFID Extension Cable and zip tie in place. Step 10: From the mounting location of the AIM2 Main Module, pull the slack from the RFID Extension Cable so that it is snug. Step 11: Tighten all zip ties and clip the extra plastic with a pair of wire snips and seal both drilled holes with silicon. Step 12: Coil any leftover slack from the RFID Extension Cable secure so it is out of the way.
AIM2 vehicle installations for vehicles using the Vehicle Speed Sensor (odometer) output. Step 1: Select mounting location for the AIM2 Main Module. Recommended locations are under the dash or under the seat that is on the same side of the vehicle as the fuel tank’s filler neck. Keep in mind the distance from the power source and grounding requirements in relation to the mounting location. Note: The AIM2 Main Module should be mounted out of harms way but, accessible for service or troubleshooting.
Step 6: If necessary, drill a hole large enough for the connector on the RFID Extension Cable to fit through, usually in a wire chase. Step 7: Plug one end of the RFID Extension Cable into one of the AIM2 Main Module’s Tank Ring Ports (Fig. 1). Step 8: Place the provided rubber grommet around the RFID Extension Cable and pass the cable through the drilled hole, fitting the grommet securely in the opening. Step 9: Route the RFID Extension Cable to the top of the fuel tank filler neck.
Figure 1 7