Installation & Assembly

ManualsBrandsSymple Stuff ManualsFurnitureSpeegle Mid Back Task Chair

PARTS LIST

ATTENTION: Before you begin to assemble the

product, please make sure that all the parts are

included in the package and in good condition.

Insert the casters (F) into the legs of the

base (C) using pressure, then place the

gas lift (E) in the middle of the base as

shown.

Place the seat (B) upside-down with its

front away from you as shown. Use screws

(H) to assemble the mechanism (D) with its

handle facing to your LEFT as shown.

Assemble the armrests (G) to the seat

(B) on their respective sides using

screws (I) and washers (J) as shown.

Place the top parts over the base parts

making sure the tip of the gas lift enters

into the hole of the mechanism.

Before seating and using the chair for

the first time, make sure that all screws

are properly tightened.

When you seat on the chair, not looking at it.

SeatBackrest

Star Base

Mechanism

Hydraulic

Gas Lift

Casters

Armrest

M6x20mm

Washers Ø 18mm

M6x35mm

Allen wrench

(Mechanism)

x10

(Armrests, backrest)

ATTENTION:

• Follow the instructions step by step.

• To avoid misalignments, leave the screws loose and do not tighten them until all are in their respective places.

• Do not overtighten or force the screws as they could break, strip, or damage the threads of the holes.

• Using the wrong size of screws on a part could result in damage to the screw or the part

4 5

x1 Right

(Armrests, backrest)

Use screws (I) and washers (J) to

assemble the backrest (A) to the seat (B)

as shown.

I (x4)

J (x4)

I (x6)

J (x6)

(Left)

(Right)

x1 Left

Summary of content (2 pages)

PAGE 1
PARTS LIST ATTENTION: Before you begin to assemble the product, please make sure that all the parts are included in the package and in good condition. A Backrest B Seat x1 x1 C Star Base D Mechanism x1 x1 ATTENTION: 1 • Follow the instructions step by step. • To avoid misalignments, leave the screws loose and do not tighten them until all are in their respective places. • Do not overtighten or force the screws as they could break, strip, or damage the threads of the holes.
PAGE 2
CHAIR’S FUNCTIONS: To raise or lower the chair’s height, pull UP the lever that is under the seat. Note: This chair does not recline. WARNINGS: • Do not stand up on the chair or use it as ladder. • Use the chair to seat only one person at a time. • Do not use the chair if parts are damaged or if screws are loose or missing. • Do not seat near the edge of the seat and always sit properly on the chair to avoid going beyond your balance point and fall off the chair.