SYMEO LOCAL POSITIONING RADAR Product Manual STU – Symeo Telemetric Unit
SYMEO Local Positioning Radar System STU Quick Start Guide 1 1.1 Overview Safety Instructions Follow the safety instructions in the operating instructions for the device and the additional documentation! Keep these safety instructions and other documents together with the device. 1.2 Installation All installation, repair and servicing work must be carried out by qualified and trained technicians! 1.3 Repairs Repairs to the device must be carried out by authorized technicians.
SYMEO Local Positioning Radar System STU Quick Start Guide Connecting and disconnecting wires refer to the instructions in the operating instructions for the device. Do not use any damaged wires (damaged insulation, exposed wires). A faulty wire poses a risk of electric shock or fire hazard. 1.6 Setup and Operation During installation, make sure that no objects or fluids get inside the device (risk of electric shock, short circuit). In emergencies (e. g.
SYMEO Local Positioning Radar System STU Quick Start Guide 2 Introduction Basic hardware setup: - GPS via u-blox LEA6 chipset Ethernet (10BASE-T/100BASE-TX, HP Auto-MDIX, Auto-negotiation) 1x Micro SDHC card 1x USB (e.g. for USB storage devices) Optional hardware: - 8 Digital inputs, opto-isolated 8 Digital outputs, opto-isolated 4 ADC inputs, opto-isolated UMTS(HSUPA/HSDPA/HSPA) or GSM(GPRS/EDGE) Modem Wifi module 802.11b/g with 802.
SYMEO Local Positioning Radar System STU Quick Start Guide 3 Connections Power connector: Positive supply e.g. 12VDC Common Ground e.g. GND Positive supply e.g. 12VDC Power has to be connected to internal 3pin terminal connector. Ground has to be connected to the terminal 2 (terminal in the middle of the connector), positive DC supply can be connected to two outer terminals. The STU is fused, protected against overvoltage and against reverse polarity.
SYMEO Local Positioning Radar System STU Quick Start Guide 4 Network settings If the basic network configuration of the STU needs to be changed, connect to the STU by any webbrowser, default address is 'http://192.168.1.99/'. First, the main web page will show up. If you choose 'Settings' in the navigation pane (left), you will be asked for username and password. Default user name is 'symeo' and password is '54all2u'.
SYMEO Local Positioning Radar System STU Quick Start Guide Here, you can change the basic network settings.
SYMEO Local Positioning Radar System STU Quick Start Guide After having edited any setting, you need to execute 'Upload changes' and after that, you need to 'reboot' the STU. New settings will only take effect after the unit has restarted.
SYMEO Local Positioning Radar System STU Quick Start Guide 5 Appendix A: Agency certifications United States (FCC) and Canada (Industry Canada) Radiofrequency radiation exposure Information: This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body.
SYMEO Local Positioning Radar System STU Quick Start Guide United States (FCC) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.