User's Guide

ManualsBrandsSyclope Electronique ManualsElectronicsTriklorame

Etape 3 : Déterminer la concentration de Trichloramine Page 15/21

User guide of the Analysis kit for Trichloramine on the air

Select "Trichloramine measurement" with the up

and down arrows then press the "OK" button

From there, follow the steps indicated by the

trikloram device

Insert the measuring cuvette into the trikloram

and press the "OK" button

Use the up and down arrows to enter the

exposure time then press the "OK" button once

each digit is selected

12 Read the value of trichloramine in the air

Push the cuvette to

the maximum

Summary of content (3 pages)

PAGE 1
Etape 3 : Déterminer la concentration de Trichloramine Page 15/21 Select "Trichloramine measurement" with the up and down arrows then press the "OK" button 9 From there, follow the steps indicated by the trikloram device Push the cuvette to the maximum 10 Insert the measuring cuvette into the trikloram and press the "OK" button 11 Use the up and down arrows to enter the exposure time then press the "OK" button once each digit is selected 12 Read the value of trichloramine in the air User guide of
PAGE 2
Etape 3 : Déterminer la concentration de Trichloramine 13 Page 16/21 Press the "OK" button to make a new measurement of trichloramine OR Press the "RETURN" button to return to the main menu OR Press the "OFF" button of the triklorame to turn off the device 3) Interpretation of the result The measurement scale will depend on the exposure time. After a minimum exposure time of 1h30, trichloramine can be measured. Scale of measurement according to the exposure time : - Exposure time <2h: 0.
PAGE 3
Etape 3 : Déterminer la concentration de Trichloramine Page 17/21 4) Error messages "Error: trichloramine concentration below the measurement scale" : This message may appear if: - the measurement made at a trichloramine level which is too low and is not within the minimum measuring range that can be measured - the analysis cuvette is poorly positioned in the trikloram and contacts with the electrodes are not well done o Reposition the cuvette, the cork must fit perfectly into the intended housing "Error: