Safety Instructions

ManualsBrandsSyber Sense ManualsElectronicsXPK-01

Table Of Contents

XPK-01 Keyfob Sensor Manual

DOC ID – 1707 • Rev 01

XPK-01 Keyfob Sensor Manual

Part number: XPK-01

Description

The XPK-01 keyfob is a battery operated wireless handheld

alarm sensor. When a button is pressed, the associated

command is sent to the panel.

Notes

 The keyfob requires that each button is programed with

the desired command (Away, Stay, Disarm, and SOS).

 The keyfob has a range of up to 100 ft. Metal, floors, and

appliances may affect the range.

Important safety instructions

Before you program this sensor, be sure to:

 Read, keep, and follow all instructions.

 When there is a low battery, replace with a compatible

lithium ion battery.

Setup

Use the panel to add and setup the keyfob.

To add the keyfob to the panel:

1. Add the sensor to the panel.

2. Once added, test the sensor.

Look at the panel, and then press Away/Stay.

Notice that the panel begins to arm.

Note: Testing all sensors to the alarm monitoring station

is strongly advised.

Button function

The keyfob has 4 buttons. Once the keypad is added to the

panel, the buttons control the arming and disarm features of

the panel.

Away: When tapping this button, the panel arms in Away

mode.

Stay: When tapping this button, the panel arms in Stay mode.

Disarm: When tapping this button, the panel is disarmed.

SOS: When tapping this button twice within 3 seconds, the

keyfob sends a panic notification to the alarm monitoring

station.

Battery replacement

The XPK-01 keyfob requires a CR2032 battery. Once the

battery is low, the panel displays a low battery icon next to the

sensor in the devices list. The battery must be replaced within

7 days of the first low battery notification. If the battery is not

replaced within 7 days, the sensor may not function properly.

WARNING: If an incompatible replacement battery is used, or

the battery is installed incorrectly explosion or damages may

occur.

Summary of content (3 pages)

PAGE 1
XPK-01 Keyfob Sensor Manual Setup Use the panel to add and setup the keyfob. To add the keyfob to the panel: 1. Add the sensor to the panel. 2. Once added, test the sensor. Look at the panel, and then press Away/Stay. Notice that the panel begins to arm. Note: Testing all sensors to the alarm monitoring station is strongly advised. Button function Part number: XPK-01 The keyfob has 4 buttons. Once the keypad is added to the panel, the buttons control the arming and disarm features of the panel.
PAGE 2
AVERTISSEMENT: Si une batterie de remplacement incompatible est utilisée ou si la batterie est installée de manière incorrecte, une explosion ou des dommages peuvent survenir. To replace the battery: 7. Place the keychain back onto the screw post, and then press the keyfob’s backplate into place. 8. Place the screw into the screw hole, and then fasten the screw into the keyfob. 9. Test the keyfob. Note: Verify that the panel is not armed before changing the battery. Specifications 1.
PAGE 3
FCC compliance FCC ID: 2AVDC-XPK-201 2004/108/EC (EMC directive): Hereby, Clare Controls, Llc. Declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2004/108/EC. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.