Specifications

Flood/Freeze Sensor

The XPF01-E-1433 is designed to detect pooling water as it makes contact across the gold probes on the

bottom of the Flood/Freeze Sensor. It also detects the potential of freezing temperatures that could cause

water pipes to burst.

Adding Sensor to the Panel

To add a XPF01-E-1433 to the panel, set your panel to sensor learning mode, tamper the sensor by

pressing the test button found on the bottom of the sensor.

Placement

Place XPF01-E-1433 anywhere you wish to detect a flood or freezing temperatures. Common locations

include behind a toilet; under a sink, dishwasher, or fridge; behind a washing machine; near a water heater;

or in a basement.

Testing

To test a XPF01-E-1433 go to test mode on your panel. Press the Test/Tamper button on the bottom of

the Flood/Freeze Sensor and hold it for at least 2 seconds. A signal will be sent to the Panel to notify you

the Flood/Freeze Sensor has tested successfully.

Battery Installation/Replacement

To change the Flood/Freeze Sensor battery, remove the rubber feet on the bottom of the Flood/Freeze

Sensor then remove the screws and casing. The Flood/Freeze Sensor requires one CR2450 battery. Be

sure to have the + side of the battery facing you. After the new battery has been replaced in the

compartment, replace the casing, screws and rubber feet on the bottom of the Flood/ Freeze Sensor.

Specifications

Signal Range: 100 meters open air

Frequency: 433 MHz

Supervisory Interval: 60mins

Operating Temperature: 0-49℃

Waterproof Rating: IP7

Battery Type: CR2450

FCC COMPLIANCE STATEMENT* This device complies with FCC Rules and Regulations as Part 15

devices.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference that may cause undesired

operation. FCC ID: 2AVDCXPF01-E-1433

Changes or modifications not expressly approved by the party responsible for compliance could void the

PAGE 1
Flood/Freeze Sensor The XPF01-E-1433 is designed to detect pooling water as it makes contact across the gold probes on the bottom of the Flood/Freeze Sensor. It also detects the potential of freezing temperatures that could cause water pipes to burst. Adding Sensor to the Panel To add a XPF01-E-1433 to the panel, set your panel to sensor learning mode, tamper the sensor by pressing the test button found on the bottom of the sensor.
PAGE 2
user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.