User's Manual
Swittons Biometric Version – User Manual
Scenario 1- Registering a new fingerprint.
• In the condition of device being completely switched off, long press
(touch) button “1”. The LED under button “1” will start blinking,
indicating the device has entered the fingerprint registration mode.
• To register the fingerprint, touch the sensor in the middle of the
device, while doing so, green LEDs will start blinking indicating
successful recognition of the fingerprint by the sensor.
• During the process of registering the fingerprint the LED in the top left
corner will change from RED to BLUE to GREEN on successful addition
of the fingerprint
• The device is now ready to use by pressing any button to place an
order
Scenario 2- Wake Up device from sleep mode.
• If device encounter inactivity for 90 seconds or more, it will go into
sleep mode.
• To wake up the device, touch the middle sensor with the added
fingerprint in Scenario 1. A green LED will light up indicating successful
recognition and red LED, if fingerprint not recognized.
• Once the LED has turned green, the device is again ready to use, and
any button can be used to place an order.
Scenario 3- Reset the fingerprints on the device.
• To reset the device fingerprints, user needs to long press button “2”
and “3” simultaneously.
• This reset the device and if need to be used again, user will have to
start again from “Scenario 1”.