CURVE500 Tx Model:CURVE500 Rx SWIT Electronics Co., Ltd.
Preface All internal technologies of this product are protected, including device, software and trademark. Reproduction in whole or in part without written permission is prohibited. All brands and trademarks of SWIT Electronics Co., Ltd. are protected and other relative trademarks in this user manual are the property of their respective owners.
Safety Precautions Please follow the safety precautions before using. The following conditions are not covered by warranty. 1. Unauthorized repairs or other Unauthorized operations. 2. Inappropriate placement including but not limited to lighting, fire, exposure to rain, water or gas. 3. Using the wrong power supply. Warning Do not get any liquid inside the products Do not block the ventilation openings or put substances inside, in order to avoid short circuit, fire or electric shock.
1. Product Introduction CURVE500 includes transmitter and receiver,adopts the latest encrypted transmission technology, Supports HDMI wirelessly transmitted in 150 meters scale(Line-of-sight), 1 channel HDMI digital video transmission, auto pairing. CURVE500 is equipped with DC power connector, compact size, portable, and the receiving signal is very stable. 2. Features HDMI Wireless transmission Support up to 1080P50/60Hz HDMI wireless transmission.
3. Appearance Instruction Transmitter CURVE500 (1) (8) (2) (9) (10) (11) (3) (4) (5) (12) (6) (13) (7) ⑴ Antenna ⑵ Product label ⑶ Link:Wireless status indicator ⑷ Video:Video signal indicator ⑸ Power:Power status indicator ⑹ Pair:0.96-inch OLED ⑺ Installation thread:1/4”-20 thread. Use the package supplied articulating arm trestle to install the device to the camera. ⑻ USB:Micro USB,software upgrade interface ⑼ HDMI in:HDMI input (standard HDMI-A type connector).
Receiver CURVE500 (1) (8) (9) (2) (10) (11) (3) (4) (5) (12) (6) (13) (7) ⑴ Antenna ⑵ Product label ⑶ Link: Wireless status indicator ⑷ Video: Video signal indicator ⑸ Power: Power status indicator。 ⑹ Pair: Pair button。 ⑺ Installation thread: 1/4” -20 thread, Use the package supplied articulating arm trestle to install the device to the camera ⑻ USB: Micro USB,software upgrade interface ⑼ HDMI OUT: HDMI output (standard HDMI-A type connector). ⑽ Battery plate: “F”plates can be used.
4. Setup connection ⑴ Connect the HDMI in interface of the CURVE500 transmitter to the HDMI out of the camera or video output device. ⑵ Connect the HDMI out interface of the CURVE500 receiver to the HDMI in of the monitor or switch station.
6. The way to get the best effective of Wireless Transmission ⑴ Set the antenna on both transmitter and receiver vertically straight up. No request to spread. (Fig.1) Fig.1 ⑵ Set the receiver as high as possible to avoid interference. ⑶ Avoid walls, trees and water to reduce signal attenuation.
7.
FCC Statement Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’ s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.