User's Manual

ManualsBrandsSwiftpoint ManualsElectronicsUSB Dongle

Quick Start Guide

Charging the Mouse

To charge your Swiftpoint GT:

1. Plug the USB charger into a USB port on your computer or into a USB charging

accessory.

2. Dock the mouse onto the charger.

The battery LED will ﬂash while charging and turn o once fully charged. A full charge

can take up to 90 minutes.

To begin using the mouse, move the switch on the underside to the ON position.

Connecting the Mouse Via USB Receiver

To connect via the USB charger/receiver, plug the USB charger/receiver into a port on

your computer and move the switch on the underside of the mouse from the OFF to the

ON position. The mouse will automatically connect to your computer.

Connecting the Mouse Via Bluetooth 4.0

Once the mouse is fully charged, you can pair it to your computer via Bluetooth 4.0.

Remove the USB charger/receiver. Leave the mouse OFF for the ﬁrst steps.

For Windows 8 or 8.1

1. Bring up the Charms menu by moving the pointer to the bottom right corner.

2. Select Settings, then Change PC Settings.

3. Then:

Windows 8

Select Devices, then Add a Device.

Windows 8.1

Select PC & Devices, then Bluetooth

from the column on the left.

4. Remove any existing “Swiftpoint GT” in the list by selecting it, then selecting

Remove.

5. While holding down either mouse button, move the switch on the underside of the

mouse to ON. The LED will ﬂash to indicate pairing mode.

6. When “Swiftpoint GT” appears in the list of searched devices, click on the device

name to install and pair with the device.

For Other Devices

Make sure your computer or device is ready to pair. Next, put the Swiftpoint GT into

pairing mode. To do this, hold down either mouse button, then move the switch on the

underside of the mouse from OFF to ON. The LED will ﬂash to indicate pairing mode.

USB charger/

receiver

OFF

CONFIG

Stylus

Scroll wheel

Docking

point

Switch

Left-click

Right-click

Tilt mouse upward

to engage stylus

Thumb grip

LED

Middle ﬁnger

grip (hidden)

If you connect your Swiftpoint GT

via Bluetooth, you can plug the USB

charger/receiver into a USB charging

accessory rather than using one of your

computer’s USB ports.

Summary of content (2 pages)

PAGE 1
Quick Start Guide Left-click Right-click LED Docking point OFF CONFIG ON Middle finger grip (hidden) Tilt mouse upward to engage stylus USB charger/ receiver Scroll wheel Stylus Switch Thumb grip Charging the Mouse To charge your Swiftpoint GT: 1. Plug the USB charger into a USB port on your computer or into a USB charging accessory. 2. Dock the mouse onto the charger. The battery LED will flash while charging and turn off once fully charged. A full charge can take up to 90 minutes.
PAGE 2
Recharging When not using the mouse for brief periods, dock the mouse on the USB charger so it maintains a charge. The first 30 seconds of charging will give you up to one hour of use. During this RapidCharge,™ the LED flashes rapidly. When not using the mouse for extended periods, move the switch on the underside of the mouse to OFF. Accessories Apply the palmrest sticker to the palmrest of your laptop. Rest the mouse on the shaded corner, and the mouse’s magnet will hold it in place while typing.