# 150 – 11938 Bridgeport Road Richmond, BC V6X 1T2 Under sink User Manual www.swiftgreenfilters.
Safety Instructions Read, understand, and follow the instructions mentioned in this manual prior to the installation and use of Swift Green Filters under sink production systems. Retain this manual for future reference. Install only on the cold lines. The maximum operating temperature of water in this filter system in 1000F (380C). The filter should be prevented from freezing. The minimum operating temperature if the water in this filter system is 400F (4.40C).
Figure 1 Single Candle system filter assembly 3
List of components (included) Quantity Component Image Single Candle Twin Candle Triple Candle Receiver Box 1 2 3 Receiver bracket 1 2 3 JG Male Connector 1 1 1 3-8 NPT X 3-8 NPT Comp Male Connector (brass) 1 1 1 Tube (3/8) sleeve and Ring set, Comp.
Before installation Open the package and remove all components. Inspect the components to make sure nothing was damaged during shipping. If any part is damaged or broken, please immediately contact the supplier for a replacement. Get familiar with the components before you start the installation of the system. Remove the items store under the sink. Have a towel in case water dripping occurs.
Connect faucet hose line to filter receiver Connect the faucet hose end to the output end of the filter receiver assembly. The output end uses a brass fitting (3/8 NPT x 3/8 NPT male connector). Set the hex nut on the faucet with threads facing tube end and 3/8” ferrule with the tapered end down. Insert the 3/8” tube insert into the tube (Fig. 4). Use a wrench to connect faucet hose to the output end of the receiver end. Pull the tube to ensure the connection is firmly secure.
Connect the water supply to the filter receiver The input end of the filter receiver assembly uses a push-in type tubing. Connect hose to the following push-in connection instructions. (Fig.7) Connect the other end of supply line hose to the cold water supply (Fig.8). Fig. 8 connecting cold water supply line to receiver refer to Fig.1 Fig.
Figure 9 (a) Turn the cartridge towards the left until it becomes loose (b) Pull out the loose cartridge SGF System Maintenance: The SGF Under sink water filter system requires very little maintenance. Just change the filter cartridges regularly as suggested below: Keep the system indoors away from extreme hot and cold temperatures, and run the system within its reasonable output capacity.