User's Manual

ManualsBrandsSWIFF TECHNOLOGY ManualsElectronicsWIRELESS TRANSMITTER & RECEIVER SYSTEM

Table Of Contents

页 1
- 1

WIRELESS TRANSMITTER

& RECEIVER SYSTEM

MANUAL

PACKAGE CONTENTS

User manual X 1

USB charging cable X 1

Transmitter X 1

Receiver X 1

Dual charging interface X 1

PRODUCT INTRODUCTION

1/4" Audio

Output/input

Micro USB

charging port

Code Button

Silicone ring

Power light

ON/OFF

Check Battery

Frequency hopping

DEVICE ON / OFF

Power on: Long press the button for 2 seconds when the transmitter and receiver are in power off state. The LED indicator light is always green, the device power

on successfully. Enter normal working condition.

* After power on, the green light of

the transmitter is always on, while

the green light of the receiver is

flashing, indicating that the device is

not connected normally.

Power off: Long press the button

for 2 seconds while the transmitter

and receiver are in power on state.

The LED indicator light is off and

the device shut down successfully.

CORRECT DISASSEMBLY METHOD

Press your thumb on the convex part of the dual charging

interface interface to remove the receiver device.

Press your thumb on the convex part of the dual charging

interface interface to remove the transmitter device.

Please disassemble the transmitter and receiver correctly according to the picture

Transmitter Receiver

DEVICE TESTING

Connect the transmitter to the guitar and the receiver to the Amplifier, long press the start button of transmitter and receiver, the green lights of the transmitter and

receiver always keeps on,enter normal working condition. If the following situations occurs, please solve as follows.

RESET CODE PAIRING

This product has been set by default before delivery and can be used directly after starting up. If the product can't be used directly, try to reset the code.

Pair code:

When a transmitter connected with

multiple receiver or transmitter and

receiver are not the original equipment,

can be long press on the code

button to red light flashing, when

transmitter and receiver normally on

a green light, namely to code success!

CONNECT

Not paring successfully: If the transmitter green light keeps

on and the receiver red light flashing, proves that the paring

is not successful.Should restart the transmitter and receiver.

No sound after paring: If there is no green light on both the

transmitter and receiver, no sound when playing,

you can try to re-pairing the products.

Device frequency hopping: When using the device, there are

signal interference around the device that cause the device

not work properly. Frequency hopping can be performed on

the device.

Frequency hopping button

DEVICE DEBUGGING

A transmitter can be used with multiple receivers.For example :

There are four effects on a stage, you can use one transmitter and four receivers Connect and performances at the same time!

Device debugging:

After turn off all the similar wireless system, use thin iron wire to long press the code button and release the button until the red light flashing on four receivers.

Use thin iron wire to long press the code button of one transmitter;release the button when the red light flashing on the transmitter and all the receivers. It will

take 20 seconds.When the green light of transmitter and receivers is always on, four receivers can receive signal from one transmitter at the same time.

One-to-many functions can be realized. All code debugging time should be completed within 20 seconds.

Summary of content (1 pages)

PAGE 1
WIRELESS TRANSMITTER & RECEIVER SYSTEM MANUAL PACKAGE CONTENTS Dual charging interface X 1 Transmitter X 1 Receiver X 1 USB charging cable X 1 User manual X 1 PRODUCT INTRODUCTION 1/4" Audio Output/input Micro USB charging port Power light Code Button Silicone ring ON/OFF Check Battery Frequency hopping CHECK BATTERY CAPACITY When the device is shut down or started up, double-click the front button, and the four green lights on the side will display the current power information, which will be off