READ ME FIRST DIY WIRELESS ALERT Gate Alert Kit EN Instruction Manual
AT A GLANCE Thank you for choosing the Gate Alert Kit from Swann. It's the ideal system to detect unwanted access into a restricted area through the gate or door. How does it work? Basically, there are two parts to the Gate Alert Kit. 1. The Indoor Alarm Receiver works as an alarm buzzer. It monitors for signals coming from the Gate Sensor, and activates the alarm and channel LED indicator in response to that signal. 2.
AT A GLANCE Getting to know the Indoor Alarm Receiver Doorbell Channel LED* Sensor Channel 2 LED Sensor Channel 1 LED Sensor Channel 3 LED Speaker Doorbell Channel button* Sensor Channel 1,2,3 buttons Mounting slots Reset button / Doorbell Chime Selection** Volume button Battery compartment * The Doorbell channel is reserved for Doorbell units (separate purchase required) and can only be used to pair Doorbell units with the Gate Alert system.
SETTING UP Battery Safety Information Replace batteries at the same time. Do not mix new and old batteries or battery types (for example, alkaline and lithium batteries). Keep batteries out of reach of children. Dispose of used batteries promptly in accordance with local regulations. Indoor Alarm Receiver Installing batteries 1. Push the release tab and lift off the battery compartment cover. 2.
SETTING UP Gate Sensor Installing batteries CAUTION: The Gate Sensor siren is extremely loud! Protect your hearing by wearing earplugs. The Gate Sensor requires 3 x AAA batteries (not included) to operate. 1. Remove the screws from the battery compartment cover, and then lift up the cover. 2. Insert 3 new "AAA" alkaline batteries, matching the polarity markings (+ and -) inside the battery compartment. 3. Screw the battery compartment cover back into place.
OPERATING BASICS Bypass feature The Gate Sensor provides a 7-second delay in which you can open the protected gate or door, and close it, without sounding the alarm. Simply press the Delay button before opening the gate or door. The status LED on the Gate Sensor will blink to indicate "Bypass" is on. If the gate or door is not closed within this time frame, the Gate Sensor will sound immediately (for 6 seconds in 3 cycles) and also set off the Indoor Alarm Receiver.
OPERATING BASICS Low battery warning Your devices will let you know when batteries are running low on power. • Install new batteries immediately for the Indoor Alarm Receiver when all four LED indicators start blinking at the same time. • Install new batteries immediately for the Gate Sensor when the status LED starts blinking continuously.
Technical Support All Countries E-mail: tech@swann.com Telephone Helpdesk USA 1800 627 2799 NEW ZEALAND 0800 479 266 AUSTRALIA 1800 788 210 UK 0808 168 9031 Limited Warranty Terms & Conditions Swann Communications warrants this product against defects in workmanship and material for a period of one (1) year from it’s original purchase date. You must present your receipt as proof of date of purchase for warranty validation.