eŸmotion R Remote Control Operating Instructions for USA and Canada R
1 2 3 1 2 3 4
Operating instructions Three functions can be controlled with the e-motion remote control: 1 = Switch on both e-motion wheels in support level 1 (LED [2] lights up briefly). 3 = Switch on both e-motion wheels in support level 2 (LED [2] lights up briefly). 4 = Switch off both e-motion wheels (LED [2] lights up briefly). Note: All remote controls are delivered in a usable state complete with battery. If the LED [2] flashes then the battery capacity is almost exhausted.
System range The e-motion remote control is designed to operate most effectively at ranges up to 10 metres. Walls and even steel constructions can be penetrated by the system. The maximum range is only attained, however, if there is a line of sight to the receiver and if there is no high frequency interference. 2 Potential causes of reduced range: - Buildings of all kinds and vegetation influence the range.
General information Please read the operating instructions carefully. alber is not liable for any consequential damages that result from the use of the device, nor for material damage or personal injury caused by improper handling or through ignoring the instructions. In such cases all claims under the guarantee are also void. The technical construction of the e-motion remote control meets national and international requirements for electromagnetic tolerances.
ON 5 4 Information for specialist dealers: Programming the wheels The remote control and e-motion wheels were synchronised at the factory. If a re-programming should be necessary, then please proceed as follows: Ÿ Place an e-motion wheel into the bracket on the wheelchair; the wheel must turn freely. Ÿ Set the DIP switch 6 [a] of the wheel to ON. Ÿ Place the rechargeable battery into the e-motion wheel. Ÿ Press the selection button [b] on the wheel once (code “learn” is started).
31.0004.4.02.00 Ulrich Alber GmbH + Co. KG D-72425 Albstadt / Germany PO Box 403 www.ulrich-alber.