User Manual

ManualsBrandsSV3C ManualsBullet Cameras4MP Poe Camera Outdoor Indoor, HD 36PCS Auto IR Lights 75-115ft Night Vision, work with NVR Blue Iris, Metal Housing IP66 Waterproof Outdoor Security Camera, Motion Alert Push, H265, RTSP

PC Software(UC)- User Manual

(Good for customers who has more than one camera since it support max 64

cameras for view the same time)

1. Device Installation

1) Use POE Switch for power supply

If connect succeed, then light will blinking as below

2) Use Power Adapter for power supply

If connect succeed, then light will blinking as below

Summary of content (9 pages)

PAGE 1
PC Software(UC)- User Manual (Good for customers who has more than one camera since it support max 64 cameras for view the same time) 1.
PAGE 2
Note: POE camera support both connection ways above Please ensure your POE switch is 48V then POE function can 2. How to download “UC” Go to our website www.sv3c.com →Download →Instruction and Software for H.265 POE IP Camera → Software, Then you can see two kinds of PC client, one for 32bit, one for 64bit, please choose per your computer to download and install (Note: Please use the administrator to run and install on the C drive, D or other drive.
PAGE 3
When your camera IP address is searched out and list on the left, then you can double click the camera ip address and view camera online (Please take note this automatic add way can only add camera succeed for First time adding, if for some reasons camera disconnect and need to add again, please follow below manually add) 2) Manually add Go to “config management”, then click “Begin to Search” to search out camera within Lan, then select camera ip address that searched out, and Click ”Batch Add” to add came
PAGE 4
. Brief instruction for more functions of UC 4.
PAGE 5
4.
PAGE 6
System – Time set up: Adjust Time Zone and set time to be accurate here System – Account Manage: Modify Camera user name and password Please take note: After you revised camera user name and password, you need to re log into UC by Manually add
PAGE 7
Media- Video Capture: Here you can set camera working mode and image flip function and image white balance modify Network- Network status: View camera IP
PAGE 8
Network – Ethernet Setup: Disable or enable DHCP here
PAGE 9
- Maintenance Restore to Factory Setting or reboot camera For other detailed instructions, please refer to our website www.sv3c.