User's Manual

ManualsBrandsSuzhou Switek Electronics & Technology ManualsElectronicsKVM SWITCH

KVM SWITCH User Manual

NOTE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

-- Reorient or relocate the receiving antenna

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)

this device may not cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to

this equipment. Such modifications could void the user's authority to operate the equipment.

PACKING LIST

The complete package of AS-21P(CS-21CA), AS-41P(CS-41CA), AS-21UA(CS-21UA), AS-41UA(CS-41UA)

2 ports/4 ports USB & PS/2 KVM SWITCH consists of:

 AS-21P(CS-21CA), AS-41P(CS-41CA), AS-21UA(CS-21UA), AS-41UA(CS-41UA) 2 ports/4 ports USB

& PS/2 switch

 User Manual

Check to make sure that all the components are present and that nothing was damaged in shipping. If you

encounter a problem, contact your dealer.

Read this manual thoroughly and follow the installation and operation procedure carefully to prevent any

damage to the unit, and/or any of the devices that connect to it.

Summary of content (11 pages)

PAGE 1
KVM SWITCH User Manual NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 2
Content OVERVIEW.................................................................................................................................................................................... 3 FEATURES ..................................................................................................................................................................................... 3 INSTALLATION............................................................................................................
PAGE 3
OVERVIEW KVM SWITCH can save money and human cost in multiple computer systems. Users need not to purchase a separate keyboard, monitor and mouse for each computer. They allow users to access and control up to 2 AS-21P(CS-21CA), AS-21UA(CS-21UA) or 4 AS-41P(CS-41CA), AS-41UA(CS-41UA) computers from a single USB/PS/2 keyboard, USB/PS/2 mouse, and monitor console. The setup is easy and there is not software to configure, this lowers the difficulty of usage.
PAGE 4
INSTALLATION For AS-21P(CS-21CA), AS-41P(CS-41CA), AS-21UA(CS-21UA), AS-41UA(CS-41UA), the connectors are on the side panel.
PAGE 5
AS-21P(CS-21CA)
PAGE 6
AS-41UA(CS-41UA)
PAGE 7
AS-41P(CS-41CA)
PAGE 8
： Mouse interface ： Keyboard interface ： Monitor interface ： Speaker interface ： Host signal interface ： Microphone interface ： Host audio/microphone interface Before installing, please make sure that all the devices are power off, and then do the following: 1. Plug the mouse, keyboard, monitor and speaker into their respective port on console section. 2. Plug the signal cable of host and audio connector into their respective port on console panel. 3.
PAGE 9
OPERATION Panel Control For AS-21P(CS-21CA), AS-41P(CS-41CA), AS-21UA(CS-21UA), AS-41UA(CS-41UA), KVM SWITCH and port status indication can be done by top panel. Buttons on panel are selection buttons. Just press one button and then you can select the corresponding port. Each button has upper and lower two LEDs indicating on line and selected status. The upper indicates the on line status. It lights if the corresponding computer is on line. The lower indicates the selected status.
PAGE 10
SPECIFICATIONS Type Computer connections AS-21P(CS-21CA), AS-41P(CS-41CA) AS-21UA(CS-21UA) AS-41UA(CS-41UA) 2 4 CPU port selection Console Front panel switches/Hot key Keyboard 1 x PS/2 female (purple) connector 1 x USB female Mouse 1 x PS/2 female (green) 1 x USB female Monitor 1 x HDB-15 female Microphone 3.5mm jack (pink) Audio 3.5mm jack (green) CPU Keyboard connection Mouse 2 x HDB-15 male 4 x HDB-15 male Monitor Mic/Audio LEDs 3.
PAGE 11
SAFE GUIDE Please follow the directions below when installing, using and maintaining it in order to guarantee the device to work well. When installing and operating the device, please make sure proper power supply first, and then do other operations after it is initialized. As signal and power transfer need custom cable, please use matched cable, unmatched cable may cause system work improperly or even damage the device. Keep airy during operation to prevent high temperature.