Installation Instruction

Suzhou Jernano Carbon Co., Ltd.
Tel: [phone]
Add: NO.398 Ruoshui Road, Suzhou Industrial Park, China;
Instructions for the use of Turbo Heat apparel heating system
1. Product model
product name
specification
control
mode
voltage
current
size
Carbon nanotube
apparel heating
system
JD–
FZ103A1C1
temperatu
re control
5V/9V/
20V
0-2A
25*25cm,19
*19cm，
19*19cm
2. Installation instruction of apparel heating system
Structure and size of carbon nanotube apparel heating system is shown in
Fig.1. Please pay attention to the sensor of temperature red marked in Fig.1.
The sensor is not pressed and bent hardly.
Figure. 1 structure diagram of the apparel heating system
3. Instruction of controllers
The heating plate is temperature controlled, divided into 4 levels, the
temperature is respectively 38℃,43℃,48℃,53℃，The use of controllers is followed
by following steps:
1) The four levels are shown by white, green,purple and red light.
2) Turn on the controller when a 5V/9V/20V battery is connected to it. LED shows
red light in the controller, which is fourth level, The temperature is 53℃.
3) LED shows red light pressed the controller one time when LED shows purple light.
The heating system is adjusted to the third level,The temperature is 48℃.