Installation Guide
PLUMBER NOTE
҃ On-site testing using higher water pressures must be conducted
with the Mixer in the closed position. (STATIC TEST)
҃ Under no circumstances is the Mixer to be opened when
exceeding the maximum stated water pressure.
҃ At the completion of testing, do not relieve any high water
pressure by opening the Mixer.
҃ Exposing the internals of the Mixer Cartridge to higher than
specified water pressures will void the manufacturers warranty
INSTALLATION GUIDELINES
҃ The Mixer is supplied assembled, only the Fixing nut and the Brass
Clamp need to be removed.
҃ Decide if the Optional Base Flange is to be used.
҃ If using the Optional Base Flange discard the smaller Base O Ring.
҃ Add the base Flange to base of Mixer and attach the Flexible Hoses
to the Mixer Hose extensions.
҃ In some cases the Flexible Hoses may need to be fed through from
under the mounting surface and then attach.
҃ Once the Flexible Hoses have been secured, lower the Mixer onto
the mounting surface.
҃ Working from underneath the mounting surface fit Clamp and
Fixing Nut.
҃ Before fully securing the Mixer ensure that the Base O Ring is
intact and the Mixer is centered over the mounting surface hole .
҃ The Mixer mounting surface must be completely water-tight.
҃ Connect the Hot and Cold Flexible hoses to the corresponding
1/2”BSP water feed lines.
҃ The 1/2” connection of the Flexible hoses have a conical seal,
ensure the mating threads are cut square and burr free.
҃ Isolating stop valves are recommended with all installations.
(not supplied)
҃ Ensure all fittings and connections are water-tight.
NOTE: Optional Base Flange must be used when the clearance
hole for mounting the Mixer exceeds 35mm. If the mounting
hole clearance exceeds 45 mm a custom made Base flange
will be required.
Pin
Handle
Handle
Body
Sink Mixer
Body
Sink Mixer
Stand
32 - 35mm
Hose extension
(Do not remove)
Base Flange
Clamp
Fixing
Nut
Surface
Flexible Hose
Voda Sink Mixer Right Hand
Product code: Available opons:
VSM Sink Mixer
VSMC Sink Mixer Curved
VSMQ Sink Mixer Square
VSMCSSRH Sink Mixer Curved 316 S/S
VSMQSSRH Sink Mixer Square 316 S/S
INSTALLATION GUIDE
sussextaps.com.au
Tapware is to be installed by a Licensed
Plumber in accordance with AS/NZS 3500:2003
Recommended working water pressure 300-500 kpa.
Maximum water temperature is 65 deg.c.
sussextaps.com.au
IMPORTANT NOTE: To provide proper function,
the Sink Mixer must be installed with the handle
to the RIGHT-HAND side of the operator.
NOTE: Mixer handle
to be RIGHT-HAND
side of the operator.