Fusion4Home® Cellular signal booster kit for the Home or Office User Guide 110518
Table of Contents Introduction Thank you for purchasing SureCall’s Fusion4Home cellular signal booster kit. SureCall’s Fusion4Home was specifically designed to eliminate frustrations over dropped calls and limited range by amplifying incoming and outgoing cellular signals in homes and offices. If you have any questions during setup, please reach out to our US-based experienced support technicians: Call: 1-888-365-6283 TABLE OF CONTENTS How it works .........................................................
Package Contents How It Works How it works Your Fusion4Home signal booster package includes the following items: 1. An outside antenna collects signal from the cell tower. 1. SureCall Fusion4Home signal booster and power supply 2. The outside antenna sends the signal to the booster through coax cable. 2. Cable for connecting the outside antenna to the signal booster (RG6, 50 ft) 3.
Before Installation Installation and hold a call. BEFORE INSTALLATION 1. Prior to securing the location of any booster parts, a “soft install” is recommended as adjustments may be needed to optimize performance. 2. Ensure adequate separation between the planned locations of the inside and outside antenna – at least 25 ft (see diagram ”Antenna Separation” on page 7). Putting your phone in Field Test mode will also indicate what level of decibels (dB) your phone is currently receiving.
Installation Installation 1. Using vertical plate of bracket, mark position of desired placement. The omni antenna should be mounted in an upright position (See “Omni Antenna Install Illustration”) Option B: Outside Yagi Antenna Before installing a Yagi, or directional antenna, note that the antenna should be mounted on a pole or pipe (not provided), at the highest possible location above the roofline – at least 25 ft above the indoor antenna – aimed in the direction of your nearest cell tower.
Installation Installation mounting location and drill through screw tab holes on booster (see “Booster Diagram” illustration) and mount the booster to a wall. Next, connect the outside antenna and booster by connecting the open end of the 50 ft. cable leading from the outside antenna to the port of the booster marked “OUTSIDE”. Option A: Whip Antenna Option B: Panel Antenna Option A: Whip Antenna Place the booster in a central location where signal is needed.
Installation LED Indicators LED INDICATORS Step 4: Connect to Power and Turn On Connect the AC power cord to the booster and plug into a 110V AC power outlet. Once the booster has been completely assembled, turn the booster’s power switch to ON. Note: If the Power LED does not turn ON or the Alert LEDs continue to flash, see the ”Troubleshooting” on page 14 section. Note: This booster is rated for 5-15V input voltage. DO NOT use the booster with a higher voltage power supply.
Kitting Troubleshooting & Specifications TROUBLESHOOTING If you have any questions during setup, please reach out to our US-based experienced support technicians: Call: 1-888-365-6283 Email: support@surecall.com Visit: www.surecall.
User Guidelines Warranty CONSUMER GUIDELINES This is a CONSUMER device BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider’s consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. WARRANTY Three-Year Product Warranty To activate your three-year manufacturer’s warranty, register at www.SureCall.
SureCall, Inc 48346 Milmont Drive Fremont, California 94538, USA 888.365.6283 | www.surecall.
