FLARE ™ Flare 3.0 /booster Flarekit with 3.0combined CA Cellular signal ™ ™ booster and booster indoor antenna Cellular signal kit with combined booster and indoor antenna User Guide 10.26.
Table of Contents Introduction Thank you for purchasing SureCall’s Flare cellular signal booster kit. SureCall’s Flare was specifically designed to eliminate frustrations over dropped calls and limited range by amplifying incoming and outgoing cellular signals in homes and offices. If you have any questions during setup, please reach out to our US-based experienced support technicians: Call: 1-888-365-6283 TABLE OF CONTENTS How it works .....................................................................
How It Works Package Contents How it works PACKAGE CONTENTS 1. An outside antenna collects signal from the cell tower. 2. The outside antenna sends the signal to the booster through coax cable. 3. The booster amplifies the cell signal and rebroadcasts the signal indoors to all mobile devices within range. 4. The booster amplifies outgoing cell signal back to the tower. Unpack all package contents. For missing or damaged items, contact your reseller.
Before Installation Installation BEFORE INSTALLATION Decibels are measured in the negatives, and a score closer to zero indicates you have a better signal. A signal of -120 dB indicates you have no service, while a score of about -50 dB means you have excellent signal strength 1. Prior to securing the location of any booster parts, a “soft install” is recommended as adjustments may be needed to optimize performance. 2.
Installation Installation Step 2. Install the Outside Antenna Outside Antenna After identifying the area of strongest signal, choose the surface where you will mount the outside antenna. Using the provided hardware, mount the outside antenna at the highest possible elevation, allowing a minimum separation of 25 feet from the planned location of the booster. min im u L-Bracket The omni antenna is omni-directional, which receives and sends signals in a 360º radius.
Specifications LED Indicators & Troubleshooting Step 4: Connect to Power TROUBLESHOOTING Once the booster and outside antenna are connected and in place, connect the power cord to the signal booster and plug into a power outlet. If you have any questions during setup, please reach out to our US-based experienced support technicians: Call: 1-888-365-6283, Email: support@surecall.com, or Visit: www.surecall.
Kitting Kitting SPECIFICATIONS Kitting Information Component Product number Gain/Loss Uplink Frequency Range (MHz): 698–716 / 776–787 / 824–849 / 1850–1915 / 1710–1755 Downlink Frequency Range (MHz): 728–746 / 746–757 / 869–894 / 1930–1995 / 2110–2155 Donor/Server Port Impedance: 75 ohm / 50 ohm Outdoor Antenna* Note LTE-A 707 MHz LTE-V 731 MHz Cellular 800 MHz PCS 1900 MHz AWS 1700 / 2100 MHz SC-289W 3 dBi 3 dBi 3 dBi 4 dBi 4 dBi / 4 dBi Flare 3.0 (U.S.) ; Flare 3.
Consumer Guidelines Warranty CONSUMER GUIDELINES This is a CONSUMER device BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider’s consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider.
SureCall, Inc 48346 Milmont Drive Fremont, California 94538, USA 888.365.6283 | www.surecall.
