Installation Manual
SC-Poly-DT-O-Kit rev3 10.25.2018
© 2018. All Rights Reserved
SureCall Flare
™
with Omni Antenna
Quick Setup Guide
This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider’s
consent. Most wireless providers consent to the use of signal boosters. Some providers may not
consent to the use of this device on their network. If you are unsure, contact your provider.
You MUST operate this device with approved antennas and cables as specied by the manufacturer.
Antennas MUST be installed at least 20 cm (8 inches) from any person.
You MUST cease operating this device immediately if requested by the FCC or licensed wireless
service provider.
WARNING: E911 location information may not be provided or may be inaccurate for calls served by
using this device.
This device may operate in a xed location only, for in-building use.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
3-Year Warranty
Activate your three-year manufacturer warranty at www.surecall.com/activate.
SureCall warranties its products for three years from the date of purchase against defects in
workmanship and/or materials.
Products returned by customers must be in their original, un-modied condition, shipped at the
customer’s expense in the original or protective packaging with proof-of-purchase documentation
enclosed and a Return Merchandise Authorization (RMA) number printed clearly on the outside of the
shipping container. RMA numbers are obtained by contacting Customer Support.
This warranty does not apply to any product determined by SureCall to have been subjected to misuse,
abuse, neglect, or mishandling that alters or damages the product’s physical or electronic properties.
For complete warranty text, including limitations and liability, see the Flare full user manual, available
online at surecall.com/support
Specications
Uplink Frequency Range (MHz): 698-716 / 776-787 / 824-849 / 1850-1915 / 1710-1755
Downlink Frequency Range (MHz): 728-746 / 746-757 / 869-894 / 1930-1995 / 2110-2155
Maximum Gain: 72 dB
Supported Standards:
CDMA, WCDMA, GSM, EDGE, HSPA+, EVDO, LTE & all cellular standards`
Impedance: 75Ω / 50 Ω
Noise Figure: 7 dB
AC Input: Input: AC 110 – 240 V, 60 Hz ; Output: DC 5V / 3A
Maximum Output Power: 1 Watt EIRP
Cable: RG6
RF Connectors: Donor: F Female; Server: Integral
Power Consumption: <12W
Certications (Flare 3.0) FCC ID: RSNFLARE-3
Best Antenna SeparationBest Antenna Separation
Step 1 Find the outside area with the strongest cell signal
Step 2 Install the outside antenna
Step 3 Place the Flare booster where signal is needed
Step 4 Connect the booster to power
Installation Overview
Have questions?
Call: 1-888-365-6283
Email: support@surecall.com
Visit: www.surecall.com/support to download the full product manual, view
tips and tricks or contact our support team
See the Flare user manual, available online for
• Detailed instructions
• Troubleshooting tips
• Full warranty information
48346 Milmont Dr, Fremont, CA 94538
1-888.365.6283 | support@surecall.com | www.surecall.com