User's Manual

Wireless Door Chime

DB-1132

Manual of Wireless Doorbell

Replacing battery:

 Please follow the diagram (1) on the right to insert batteries.

DIAGRAM 1

Tone Setting

 The switch (MUSIC SEL) can be used to set up to 4 musical modes

such as Ding-Dong ;Ding-Ding; Song of Alice and Song of Westminster.

If you like to switch the modes, you only need to hold the button (MUSIC

SEL) for 2 seconds after the previous one finished. To adjust the volume,

please tune the button(VOL) by a flat blade screwdriver.<Ref to the

diagram (2) for reference>

DIAGRAM 2

Code Setting

 The code is set by the manufacturer, and there are combinations of

codes up to 256. In order to avoid the interference, you can set the code

by adding or removing jumpers of the doorbell. Please make sure that

the code setting of the transmitter must match with that of the receiver.Eg.

If the code of the receiver is 6,7,8 ;the code of the transmitter must also

be 6,7,8. If the interference continues, please re-set the code anddo the

same procedure for both transmitter and receiver.<ref to diagram(3)>.

DIAGRAM 3

Mounting on the wall

 Please remove the back of the case by pushing in the tab on the

bottom by screwdrivers. Mount the back of the case on the wall and snap

the front case back on. In case of using double side tapes, please ensure

the wall is dry and clean.<ref to diagram(4)>

PAGE 1
Wireless Door Chime DB-1132 Manual of Wireless Doorbell Replacing battery: Please follow the diagram (1) on the right to insert batteries. DIAGRAM 1 Tone Setting The switch (MUSIC SEL) can be used to set up to 4 musical modes such as Ding-Dong ;Ding-Ding; Song of Alice and Song of Westminster. If you like to switch the modes, you only need to hold the button (MUSIC SEL) for 2 seconds after the previous one finished. To adjust the volume, please tune the button(VOL) by a flat blade screwdriver.
PAGE 2
Warning: Changes or modifications not expressly approved by the party responsible for compliance would void the user’s authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.