User Manual

ManualsBrandsSuptek ManualsElectronicsTV Wall Mount Swivel Tilt Rotation Full Motion Adjustable Articulating for Most 15-27 inch LED, LCD Monitor Wall Mount VESA 75,100

Table Of Contents

Installation Instruction

MA2720

UNPACKING INSTRUCTIONS

Carefully open the carton, remove contents and lay out on cardboard or

other protective surface to avoid damage.

Check package contents against the Supplied Parts List in the next page

to assure that all components were received undamaged. Do not use

damaged or defective parts.

Carefully read all instructions before attempting installation.

IMPORTANT SAFETY INFORMATION

Install and operate this device with care. Please read this instruction before

beginning the installation, and carefully follow all instructions contained

herein. Use proper safety equipment during installation.

Please call a qualified installation contractor for help if you:

If you don’t understand these directions or have any doubts about the

safety of the installation.

If you are uncertain about the nature of your wall, consult a qualified

installation contractor.

Do not use this product for any purpose or in any configuration not

explicitly specified in this instruction. We hereby disclaims any and all

liability for injury or damage arising from incorrect assembly, incorrect

mounting, or incorrect use of this product.

75X75

100X100

15” - 27”

13kg

(28lbs)

MAX

57-415MM

(2.25'-16.3')

VESA Pattern

Bearing Range

Applicable Size

Profile

1：Remove the screw

shown in the figure

with a screwdriver

2：Then lift the panel

up by hand

Step 2 Removal of the panel

C or D

Step 3 Install the TV

Step 4 Panel installation Step 5 Fix the panel

Reinstall the

screw removed

in step 2

Hang the panel into

the head-stock

Insert the two wire clips (E) into the

hole in the lower side of the square

tube to complete the routing. Use

the wrench (G) and wrench (F) to

adjust the tightness of the joint.

Hold the left and right sides of the TV,

can adjust the rotation about the TV.

If the rotation adjustment is too loose

or too tight, use wrench (F) to tighten

or loosen the nut on the figure shown

to control the tightness of left and right

rotation adjustment.

Step 6 The cable arrangement and the adjustment of the joint tightness

360°

Summary of content (2 pages)

PAGE 1
Step 2 Removal of the panel Step 3 MA2720 Install the TV Installation Instruction 2：Then lift the panel up by hand 1：Remove the screw shown in the figure with a screwdriver C or D H MAX Step 4 Panel installation Step 5 Fix the panel 75X75 100X100 VESA Pattern 13kg (28lbs) 15” - 27” Bearing Range Applicable Size 57-415MM (2.25'-16.3') Profile UNPACKING INSTRUCTIONS Carefully open the carton, remove contents and lay out on cardboard or other protective surface to avoid damage.
PAGE 2
Supplied Parts List Step 1 Install the Wall Plate to the Wall Brick wall B A （2）Self-Drilling Screw-B （4）M4*10 Screw -C （4）M5*16 Screw-D I 55mm 50mm （2）Cable Clips-E （1）Wrench-F （1）S5 Allen Key-G （4） 5Washer-H Wood wall A （1）Bracket-I CAUTION! WARNING I This TV mount must be securely attached to the vertical wall. If the mount is not properly installed it may fall, resulting in possible injury and/or damage.