Installation Manual

Step 2
Step 3
Step 4
Check the tightness of panel by left and right rotation
Attach VESA Plate to the mounting holes of the monitor
Installation of cable clips，cable arrangement
and joint adjustment
Installation Instruction
MA2720 English
UNPA
CKING INST
RUCTIONS
Carefully open the carton, remove contents and lay out on cardboard or
other protective surface to avoid damage.
Check package contents against the Supplied Parts List in the next page
to assure that all components wete received undamaged. Do not use
damaged or defective parts.
Carefully read all instructions before attempting installation.
IMPORTANT SAFETY INFORMATION
Install and operate this device with care. Please read this instruction before
beginning the installation, and carefully follow all instructions contained
herein. Use proper safety equipment during installation.
Please call a qualified installation contractor for help if you:
If you don’t understand thesedirections or have any doubts about the
safety of the installation.
If you are uncertain about the nature of your wall, consult a qualified
installation contractor.
Do not use this product fof any purpose or in any configuration not
explicitly specified in this instruction. We hereby disclaims any and all
liability for injury or damage arising from incorrect assembly, incorrect
mounting, or incorrect use of this product.
H
C or D
。
F
Rotate the panel by hand as shown in the figure, if turning
easily, tighten the nut with the wrench(F); if turning hard,
no need to use the wrench(F).
www.suptekmount.com
Insert the two wire clips (E)
into the hole in the lower
side of the square tube to
complete the cable
arrangement.
Use the wrench (G,F) to
adjust the looseness of the
joint.
G
E
F
75X75
100X100
15” - 27”
13kg
(28lbs)
MAX
63-381MM
(2.5'-15')
Mounting pattern Suggested
Screen Sizes
Maxximum Load Distance from
the wall