Simeon Audita Portable Soundfield System User Manual
Notice: The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure requirements and void user’s authority to operate the device. This device complies with part 15 of the FCC Rules.
Simeon Audita Portable Soundfield System Your new Simeon Audita portable soundfield system provides convenient and portable amplification with a choice of dual FM or digital transmitter formats. The system can be set up in any classroom or meeting room and is easy to transport. It also interfaces simply with a Simeon OmniPanel setup, giving the portable system the power of a permanent installation.
Simeon Audita Portable Soundfield Receiver Figures 1 & 2 1. Power ON/OFF switch with power indicator 2. Display Screen 3. Volume Control 2 4. Set Button 5. Cursors 6. Power adapter plug (20V) 7. Speaker Output 3 4 1 5 8. Speaker Switch 9. Auxiliary RCA Input with gain control 10. Voice Priority Button 11. Wall mount keyhole 12. Tone Control 13. AUX Out Gain 14. AUX Out Equalizer 15. Battery Housing 16.
Setup Carefully unpack the soundfield system and separate its components. Simeon Audita Portable Soundfield Receiver Your Simeon Audita System includes either a dual-digital and a dual-FM receiver module, to be used with the corresponding Simeon transmitters. It also includes an integrated speaker, and multiple inputs and outputs. It is at the core of the entire sound system. It is recommended that you charge the receiver fully before its initial use. Identify the correct power adapter for the receiver.
Simeon Omnipanel 900 Flat Panel Loudspeaker Figures 3 & 4 17. Speaker Panel 18. Exciters (Piezoelectric Drive Elements) 19. Receiver Input 20. Fastening Knob 21.
Simeon 5T and 6T Pendant Transmitter The Simeon 5T Transmitter has 96 channels available over an UHF frequency band to allow for the best possible sound quality and performance. The Simeon 6T Transmitter offers 16 high definition digital audio channels, each with two positions (A & B) that allow for easy setup of two transmitters side by side, and can be used in any country. Your transmitter can be interfaced with a boom (headset) mic, as well as other audio inputs.
Simeon 5M and 6M Hand-held Transmitter/Microphones Figures 5, 6 & 7 22. Microphone Capsule 23. Power ON/OFF Button 24. Display Screen 25. Control Wheel 26. Talk/Mute Button 22 23 24 25 27. Battery Housing 28. Charging Dock Connector 27 28 Cursor SET 26 Cursor Simeon 602 Transmitter Charging Cradle Figure 8 44 45 29. Power Cable Plug 30. Charging Pockets 31.
Operation Check that the transmitters and receiver modules are set to matching channels. With the Simeon Audita FM System, make sure that the selected channel frequencies do not conflict with other FM equipment nearby. It is important that separate channels are selected for each system in one location.
Simeon 5T and 6T Pendant Transmitters Figures 12 & 13 32. Power ON/OFF and Talk/Mute Button 33. Set Button 37 36 34. Cursors 35. Display Screen 36. Microphone Capsule 37. Auxiliary Input Jack “Aux In” 38. Alternate Charging Plug 39. Charging Dock Connectors 40. Belt Clip 35 41. Lanyard Hook 34 43. Neck Strap Hooks 42.
Simeon 5T and 6T Pendant Transmitters To turn the Simeon 5T or 6T on, hold the power button on the front of the transmitter [21], until the display screen reads “On”. This screen shows both the channel selection and the battery status. Adjust the volume control corresponding to the Digital position (A or B) or FM channel (1-96) displayed on your transmitter. The capsule of the Pendant Transmitters [25] is highly directional - point the top of the transmitter directly towards the mouth for best performance.
Assigning Channels FM Transmitters 5T and 5M, and the Simeon FM Dual-Receiver Module, all part of the Simeon Audita FM System, feature a simple-to-use menu that allows selection between 96 UHF channels. To assign a new channel, press the SET button until the displayed channel flashes. Use the up and down cursors to select the new channel. Press SET again to confirm the new channel selection. Make sure that the transmitter channel matches that of the corresponding receiver module.
External Connections The side panel of the Simeon Audita has several external connectors. These can be used to connect devices other than the two transmitters to the receiver. In the left of the side panel there is an auxiliary RCA input jack with gain control [9]. This can be used for connecting external audio sources, such as computers and iPods to the receiver with the appropriate cable. On the right of the side panel there is a 3.5mm auxiliary output jack [13].
Setting Gain Level Check the volume position of both channels before turning the system on! Turn the Simeon Audita ON at the master power switch on the front of the system [1]. The Simeon Audita comes with two independent volume controls – one for each transmitter. With the transmitters turned ON and microphone positioned correctly, slowly increase the volume controls to a comfortable listening level. Avoid excessive amplification – speech should be comfortably audible throughout your listening area.
Useful Tips • Wear the pendant transmitters with the belt clip or lanyard and boom mic for comfort and ease of usability. • Adjust the boom mic headset for comfort, and ensure that the microphone is positioned correctly. • By selecting the Secondary (S) position for the switch inside the 5M and 6M battery compartment, the handheld can be controlled remotely from the pendant transmitter.
Microphone care The microphone is the most delicate component of your soundfield system. Protect the microphone from strain and excessive force. Clean the pin of the microphone plug regularly and replace damaged or missing windscreens and protect the microphone capsule from moisture. The Simeon 623 boom (headset) microphone has a unidirectional pick-up pattern. The tip of the mic capsule must be pointed towards the corner of the mouth for proper performance.
Troubleshooting No Sound Check the Speaker Switch on the side of the receiver. Check that the transmitters and receiver are both turned on, and that the transmitters are not set to MUTE. Verify that the Simeon Audita receiver battery is charged, or else plugged into an AC supply with the correct power adapter. Check or replace transmitter microphone. Check that the transmitter batteries are charged.
System Technical Specifications Simeon Audita Overall System Specfications Output power 40W (RMS) Speaker types 5” Neodymium, 1” tweeter Audio control Gain, Tone control, 3-band on auxilary output Auxiliary input Single RCA connector. Input sensitivity 350mV Auxiliary output 3.5mm mini plug. Output level 1V Speaker control Internal Speaker / External Speaker select switch External speaker output Single Speakon Connector, 4 Ohm Power requirements 100 ~ 240VAC / 20VDC, 3.
Receiver Module Technical Specifications With RD5 FM Dual Receiver Module UHF Frequency range 640~664MHz (Canada & USA); 863~865MHz (Europe) Number of channels Canada & USA frequencies: 96; European frequencies: 16 Squelch Adjust OFF - 100 ± 3dBm Total harmonic distrotion <1% Signal /noise ratio > 65dB Audio frequency response 70 Hz ~ 17kHz Operating range Transmission 50 ~ 70m (160 ~ 230ft) Transmission Latency Real time Operating temperature -10°C ~ +60°C (14°F ~ 140°F) Certifications In
Radio Frequency Transmitter Technical Specifications Simeon 5T FM Transmitter Internal microphone type Electret condenser UHF Frequency range 640~664MHz (Canada & USA); 863~865MHz (Europe) Number of channels Canada & USA frequencies: 96; European frequencies: 16 Radio signal power High: 10dBm; Low: 3 ± 2dBm Operating range 50 ~ 70m (160 ~ 230ft) Max modulation ± 40KHz with level limiting Battery type 3.
Digital Transmitter Technical Specifications Simeon 6T Digital Transmiter Internal microphone type Electret condenser Frequency range 2.4 ~ 2.5GHz Number of channels 16 Channel pairs Radio signal power High: 3 ~ 6dBm and Low: -3 ~ -10dBm Operating range 25m (>80ft) Digital pairing range 15m (50ft) Battery type 3.7V 1200mAh (Lithium ion) rechargeable, replaceable at service centre Autonomy 24 Hours Charging time 4 ~ 6 hours Ext. microphone input 3.
Supportive Hearing Systems, Inc. 283 MacPherson Ave., Toronto, ON, Canada M4V 1A4 T: 416-236-4898 | F: 416-483-6210 T: 1-800-732-8804 | F: 1-800-597-3143 e-mail: info@SimeonCanada.com www.SimeonCanada.