User Manual

Product Safety Instructions

1. Read and understand all instructions.

2. Follow all warnings and instructions including those

marked on the product.

3. Changes or modifications to this product not

expressively approved by the manufacturer will void

the warranty and the FCC authorization to operate

the equipment. Use only manufacturer provided

accessories.

4. Do not use the telephone near water. Never spill

liquid of any kind on this product.

5. Unplug the product from the wall telephone jack and

power outlet before cleaning. Do not use liquid or

aerosol cleaners. Use damp cloth for cleaning.

6. Do not place this product on an unstable cart, stand

or table. The product may fall and cause personal

injury or damage to the product or other property.

Place the base station and the charger on hard, flat

surfaces.

7. Power Outage:

In the event of a power outage, your handset

charger will not recharge the handset battery, and

the base station will not allow you to make an

outgoing call or take an incoming call. Both the

charger and the base station require electricity for

operation. You should have a telephone that does

not require electricity available for use during power

outage, or have a temporary backup power supply.

8. Slots or openings in the product’s housing are

provided for ventilation. These openings must not

be blocked or covered. Placing the product on a

bed, carpeting, or other similar surface may block

these openings and should be avoided. This

product should never be placed near or over a

PAGE 1
Product Safety Instructions 1. Read and understand all instructions. 2. Follow all warnings and instructions including those marked on the product. 3. Changes or modifications to this product not expressively approved by the manufacturer will void the warranty and the FCC authorization to operate the equipment. Use only manufacturer provided accessories. 4. Do not use the telephone near water. Never spill liquid of any kind on this product. 5.
PAGE 2
radiator or heat register, or in a built-in installation unless proper ventilation is provided. 9. Never push objects of any kind into this product through housing slots/openings as they may damage the product, touch dangerous voltage points or short out parts that could result in fire, electric shock, or injury. 10. This product should be operated only from the type of power source indicated on the marking label.
PAGE 3
18. Unplug the base station or the charger adaptor from the wall power outlet and refer servicing to an authorized service center under the following conditions: a. If liquid had been spilled into the product. b. When the power supply cord or plug is damaged or frayed. c. If the product has been exposed to rain or water. d. If the product does not operate normally by following the operating instructions. e. If the product has been dropped or housing has been damaged. f.